translation modifier will always be connected to the last datum reference in the feature control frame right?
@sanketpatil3243
4 жыл бұрын
Can you make video on how to measure gap & flush , flange creation , material addition to avoid sinkmar by using catia software
@sharathgs19
4 жыл бұрын
Nice video... I feel datum B gauge should be related AME since it has orientation wrt DTM A
@mechanicalvault
3 жыл бұрын
In demonstration, I have not considered datum A. I am just trying to show hole to hole relationship of datums. But yes, if you take the example which I took as it is, then both datum B & C have to be Related AME. In that case, we have to rest the block on datum A first before we establish AME of Datum B and datum C.
@sharathgs19
3 жыл бұрын
@@mechanicalvault yea I was talking on the example you took.... Thanks for the information
@bhaskarreddy7397
4 жыл бұрын
Sir pls do one vedio of sheet metal related to k factor bend allowances bend detection and about neutral axis basic calculations in interview every one asking.
@mechanicalvault
4 жыл бұрын
Coming Soon!
@beautyofnature9848
3 жыл бұрын
Sir Is there any tolerances for translation, or it will move to mate with the second hole
@mechanicalvault
3 жыл бұрын
We still have to meet geometric tolerance between datum features or FOS. Translation just allow to adjust datum gage to stabilize the part for measurement. Once it stabilizes, then we have to check if part is meeting FCF requirement or not. Without translation, part might have measurement error itself.
@ranjithck2265
4 жыл бұрын
Sir, could you please make a document on three plate mould? How it works, what are the criteria to be considered. A detailed one please?
Пікірлер: 11