Just checking the fluids for the first time on my newly acquired S2A and could not find the transfer box fill plug. Thanks for this!👌👍
@Hectorious2
9 жыл бұрын
I like the pressure bottle idea. I'll use that, as I have a spare sprayer with a broken nozzle.
@walterburke1666
9 жыл бұрын
Thanks for posting this, very helpful, great idea with the garden sprayer.
@AllotmentHolder
9 жыл бұрын
Hi David I see no issue with top filling and I think some do this. I tend to use the factory filling points as this puts the oil straight into the correct reservoir position. Some areas especially in the top of the box may be expecting only a very fine oil spray, as the bulk of the oil will be in the bath below. By filling through the top the incoming oils path may take a large volume of oil into areas its not expected or designed to be. Just my thoughts Ian
@baldylee100
10 жыл бұрын
Looks much easier without an overdrive in the way, haha!
@AllotmentHolder
8 жыл бұрын
I haven't got one!
@davidgoodson7878
9 жыл бұрын
why dont you use the holes at the top of the gear box and t case?
@michaeldeery9654
5 жыл бұрын
Do the transfer box and the gearbox share the same fluid, I ask because I just added an overdrive and replaced the transfer box fluid. I had just replaced the gearbox fluid a few months ago. I could just check to see if it is filled to level.
@AllotmentHolder
5 жыл бұрын
No they normally all have separate reservoirs including the OD so you now have 3
@javier5066
6 жыл бұрын
What size are the square oil filler plugs and what did you use to remove them? The transfer box filler refuses to budge and I'm afraid of wearing the head without the right tool. Thanks!
@AllotmentHolder
6 жыл бұрын
I think it's a 1/2 square drive - but please check in the manual - do not use metric on an old Land rover as it will likely round off. Needs to be a tight fit.
@highdownmartin
4 жыл бұрын
Moles ad a blow lamp. Just to make sure it comes out. Then replace with a new un buggered one
Пікірлер: 14