This is great. But aren't you supposed to use cycloid curves instead of circular arcs? Or is this design different than a cycloid gear? If so, how do the two compare in terms of performance?
@doenerjonesrofl
4 жыл бұрын
Came for the engineering, stayed for the music
@LegionnaireENR34
11 жыл бұрын
Nice video, but a bit of explanation would have been useful too. I mean - how do you choose small circle diameters at the very first step, the ones that are supposed to be copied 7 times? How do you draw larger circle that is tangential to the smaller ones - where is it's centre and/or its diameter, how do you draw it? What does the smaller circle with centre at (0;0) represent?
@Feinwerk-uhrentechnik
11 жыл бұрын
I'm working with a CAD program made specially for watchmakers - it's called TellWatch and comes from Switzerland.
@MuhammadAfzal-jm6cw
2 жыл бұрын
Hi
@dylanrcoh
10 жыл бұрын
Salwald, I thought I should let you know that this video really helped me analyze gerotor movement. I figured everything out, and did an entire science project on these types of gears, even getting a set 3D printed! I'm putting this youtube video as one of my sources for my report. Thanks!
@samhorn6424
11 жыл бұрын
if you draw a line between the circle centers and the outer/inner gear mesh points, they'll all have a single point of intersection. so, in addition to the constraint that they be equally radially spaced from your eccentric (outer gear) center, you should be able to figure out their location.
@MilesAway429
11 жыл бұрын
How did you decide/calculate where to put your '8 fictive circles'? this is the only bit I am stuck on so far.
@richardmoats4481
10 жыл бұрын
slightly confused as to what you use to figure out how to make the 8 outer lobs and how you define where they go
@dylanrcoh
11 жыл бұрын
With what program did you make the simulation that you showed at 1:05?
@low-budget-projectsgermany7688
5 жыл бұрын
Mit was für einem Programm wurde das erstellt ? Spezielle die Animation der bewegten Baugruppen
@rajmohanbharathan6447
6 жыл бұрын
how to generate ports on the pump covers ,for newly designed rotors, for optimum efficiency
@derskyflo
8 жыл бұрын
Können Sie die verwendeten Maße angeben? Ich komme nur zu dem Teil mit den 10°. Wie man das macht verstehe ich leider noch nicht. Von welchem Punkt aus werden die 10° angewendet?
@SameerMohammadAbdullah
11 жыл бұрын
what's the name of the music please ?
@Holmnielsen-
10 жыл бұрын
What's the application for this?
@Feinwerk-uhrentechnik
10 жыл бұрын
Generated rotors (Gerotor) are usually used in pumps - but thy could also be used in special gears etc.
@fkgmail
5 жыл бұрын
Could you teach me how to design the profile step by step(like another video)? Because I couldn't draw without dimensions. I would like all the dimensions. And I am not able to understand how to spin the rotor(1:28). pls.thx.
Пікірлер: 17