Thanks for a wonderfully and patiently explained video. I want to model a single 18650 cell with heat generation and natural convection alone. But while running the simulations, rather than converging, static temperature of my battery is rising suddenly after increasing the iterations. so what should I do ? how can I decide on optimal number of time steps?
@FrontiersInCFD
10 ай бұрын
Select suitable mesh size and accordingly select time step size.
@arjunprasanthU
10 ай бұрын
@@FrontiersInCFDDo you mean to say that Courant number be considered ? If so what should be the fluid velocity since its natural convection ?
@FrontiersInCFD
10 ай бұрын
Velocity is difficult to change as per flow however we can change mesh size and time step size
@user-sl9lj6hz2t
Жыл бұрын
Thanks for useful video for simulating li-ion battery pack. I'd like to analyze air cooling of battery pack consist of 70s 6p 21700 cell using MSMD model. But, there's no suitable guide for it. So could you make video or some advice for it please?
@FrontiersInCFD
Жыл бұрын
Will do !
@sdkavisne6096
Жыл бұрын
mükemmel
@ciniclipsandclicks2000
Жыл бұрын
its showing that inalid colouring range for volume rendering 1.what to do?
@FrontiersInCFD
11 ай бұрын
Select appropriate variable
@bharathvislavath4414
5 ай бұрын
what should be the boundary conditions if air has to pass over the battery pack (IP67 Battery pack)? Anybody please
@FrontiersInCFD
5 ай бұрын
select air as working fluid during material selection define the fluid zone for air
@bharathpawar8400
5 ай бұрын
Thank you
@sriharshajasti6245
6 ай бұрын
how can we change the battery nature from Li to NCM?
@FrontiersInCFD
6 ай бұрын
Change material
@tharathankaraj1950
Жыл бұрын
Sir ,thank you for this video.Can we do simulation using one cell of battery?
@FrontiersInCFD
Жыл бұрын
Yes it can be done. Even it will take less time for simulation as compared to this
@tharathankaraj1950
Жыл бұрын
Thank you sir
@bharathpawar8400
5 ай бұрын
What is the meaning of reference zone?
@FrontiersInCFD
5 ай бұрын
If fluid is flowing from inlet to outlet for the flow reference zone is fluid
@KundanKumar-sc7kc
6 ай бұрын
sir , i have done same but no pcm contact region is showing
@FrontiersInCFD
6 ай бұрын
wa.me/message/AAWWIVF5QK7OP1 share the images here
@tharathankaraj1950
Жыл бұрын
Sir ,Is there any course regarding simulation of batteries only?
Пікірлер: 37