The most prestigious air-conditioning service in Hanoi 0965 867 189 shared the experience of installing air-conditioners, guiding the installation of air conditioners in part 1 of the cold-surface support rack, aligning the air-conditioning position properly.
suadieuhoa.edu.vn/
suadieuhoa.edu.vn/lap-dieu-hoa/
suadieuhoa.edu.vn/lap-dat-die...
Proceed as follows:
The indoor unit is hung on the wall, about 5 -10cm from the ceiling (with a wall-mounted air conditioner). Remove the mounting bracket that is installed at the back of the indoor unit, use the indoor unit rack to locate and measure the installation size, balance the level of the travel bracket, (note that the rack must be balanced but it is best to slope the exit pipe. water from 0.5 to 1mm so that the water in the trough is easier to drain). When taking the mark to drill, then screw the rack up on the wall.
Use a screwdriver to remove the cover on the outside of the indoor unit for wiring, signaling wires according to the instructions in the accompanying book.
Pinch the copper pipe to match the hole, remove the plug, seal the 2 ends with adhesive tape, avoid dust and dirt from entering.
The insulation cover, tape cover includes water pipes, copper pipes, wires into a block that passes through the drill hole to go out.
Measure the distance from the cold rig to the hot rig. Note that the distance from the outdoor unit to the indoor unit should not exceed the manufacturer's specified limit.
Flared copper pipe and connect pipes to the indoor unit.
Негізгі бет Тәжірибелік нұсқаулар және стиль Giáo dục Giáo hoàng | Phần 1 của chúng tôi chỉ có thể sử dụng 0965867189
Пікірлер: 16