Added side lights and turn lights, but kept the original two pole GIVI connectors to preserve the advantage of the docking plate.
In reply to most of your questions:
1. It is a DIY project built entirely by myself, (not an AdMore kit or anything similar)
2. It uses a transmitter mounted below the bike seat and a receiver mounted inside the box
3. The two pole connector is used as a switched 12 volts supply only
4. Circuit diagram can be downloaded from this link bit.ly/jsammut_givi
5. The original HT6320 and HT6350 are (unfortunately) no longer available from the manufacturer. However you can use other tx /rx pairs such as HT12E / HT12D
6. For a better quality video, please refer to my recent similar project carried out on another GIVI box E370 on this link • GIVI E370 brake and tu...
Hope this helps and answers your questions
regards,
John
Негізгі бет GIVI V46 brake light modification.mp4
Пікірлер: 34