in my personal opinion this is a fake. or rather the glass isn't tempered
@samuelporter9477
7 жыл бұрын
kottir ive read you can cut or grind 5-20mm into the edge of tempered glass with a low risk of failure, so this is plausible to me, id like to see them try cut a pannel in half.
@leaderglasschina5373
6 жыл бұрын
What can I do for you.
@leaderglasschina5373
6 жыл бұрын
Why say so?
@emilcodes549
6 жыл бұрын
LEADER GLASS CHINA hello dear,do you have wechat?
@leaderglasschina5373
4 ай бұрын
Yes. Thank u. We cutting, washing and drying, finally tempering.
@bluelightningfilms57
7 жыл бұрын
Hi, I was just wondering what the thickness of the glass panel you cut was. I have a friend that has a water jet cutter which he normally uses for metal, but could it be used for glass? The goal is cutting 3mm-5mm thick glass, and I am trying to figure out if we can do that.
@katter2000
7 жыл бұрын
sure u can if it's not tempered
@leaderglasschina5373
6 жыл бұрын
Our cutting machine is used for glass, not for metal. Normally the glass cutting machine can make the holes from 3mm to 19mm.
@1petrofski
6 жыл бұрын
Don't try cutting after tempering the glass as will break into hundreds of pieces
@1petrofski
3 жыл бұрын
@kosmosleha Yes if it's tempered glass you cannot cut it at all, if it's laminate safety glass you will be able to cut it with a glass cutter
@leaderglasschina5373
4 ай бұрын
@@1petrofski Yes. Thank u. We cutting, washing and drying, finally tempering.
@umagi3d808
2 жыл бұрын
Misleading title. This is normal glass cutting, not tempered glass.
@jmackman
Жыл бұрын
Incorrect. You CAN water jet tempered glass. Just gotta START outside of the glass, then proceed to cut into it slowly. its basically just sanding a line through it. You cant pierce cut tempered glass. That is when it breaks.
@leaderglasschina5373
4 ай бұрын
We cutting and edging the glass before Tempered.
@idolomoro53
6 жыл бұрын
Tempered or laminate?
@leaderglasschina5373
6 жыл бұрын
It is normal glass. When we finsihed holes, then toughened. Normally we make the holes on the glass before we toughened or laminated.
@Flyboard12345
2 жыл бұрын
It’s not tempered
@leaderglasschina5373
4 ай бұрын
It is on cutting then washing and drying, finally tempering.
Пікірлер: 24