can you share the connections you needed to hook up to get this going? I am working on a very similar project - a 2012 F450 and I cant get the ecu to connect on the bench. Thanks!
@globalcommerce7654
3 жыл бұрын
What ended up being the problem to ckp sensor?
@mfiqirofili2370
2 жыл бұрын
Nice
@prospexican
2 жыл бұрын
why does the 12/30 V switch need to be turned on for ?
@douggregory2922
2 жыл бұрын
Could you use this setup to bench flash that PCM?
@adrianojeminaj9860
2 жыл бұрын
120 ohm resistor do you use ? For protocol can
@crownafro-euro524
Жыл бұрын
What is that software for the wiring diagrams called
@sciCHD
Жыл бұрын
Ouaip we dont care about music, it's good to speak out what you're doing during doing it
@rogelioesquivel5315
Жыл бұрын
I just bought one .. what magnifier light are you using
@cap3105
3 жыл бұрын
What model tablet?
@cap3105
3 жыл бұрын
So I got the Goddiag any way you can help with what pin I need to connect for obd2 reader I have power and ground so far thanks
@jamesbarratt593
3 жыл бұрын
the answers were like you'd asked a completely different question. The tablet is Autel Maxisys ULTRA
@ramirovelascopaz851
Жыл бұрын
No se entiende nada lo q aces mejora o deja de crabar
Пікірлер: 14