Last week we fabricated a full set of custom headers to route our '65 Continental exhaust from our 7.3L Godzilla engine, around our steering shaft, and past our firewall. Now it's time to work our way to the back of the Continental. We have to start first by cutting out the trunk of this 1965 Lincoln because we have something wild planned for the very end of this exhaust run.
Once the trunk is chopped out, we can start working our way from our headers back. We're connecting our band clamps to two massively long Vibrant oval exhaust pipes. These will run the length of the Continental until getting to our differential, where we're using some bent Vibrant oval piping to pop over our rear end and into our trunk area. And that's where the real fun begins.
We have an insane Vibrant muffler that we're throwing right where our spare tire used to be, connecting both sides of our exhaust, and combining them into an exhaust tip that's shooting right through our custom fabricated bumper!
Want to hear how this exhaust sounds? Well so do we! But just like us, you're going to have to wait until this build gets farther along. And the only way to do that is to subscribe. So make sure you don't miss a single part of this 7.3L swapped bagged Lincoln Continental Build!
.
Get caught up on this build and catch even more of the S2S madness here:
Godzilla Continental Grill Fabrication
• Godzilla Swapped Linco...
Slammed & Supercharged C10 First Test Drive
• LS3 Swapped & Supercha...
Custom C10 Center Console & Interior Assembly
• '72 C10 Center Console...
454 Inner Fender Fabrication
• Chevy 454SS Inner Fend...
Негізгі бет Автокөліктер мен көлік құралдары Godzilla Swapped Contiental Trunk & Bumper Exit Exhaust Fabrication - 7.3L 1965 Lincoln Ep. 10
Пікірлер: 176