Yes I want to get those but I want to see what’s involved in to installing them Install videos would definitely help
@WhiteRG24
2 ай бұрын
Hi, How much did the vibration levels increase after fitting this kit? I ask because I fitted the same kit to my RG24 following the instructions and the comments and tips in this video. The OE istaltors are in the right place. The bushings of ALLOY ART are positioned correctly. The level of vibration is significant - especially when letting off gas. The vibration is strongest in the 2500-3500 rpm range. Even the steering wheel shakes a lot. Wouldn't a rear frame stabiliser solve this problem without increasing vibration?
@Garage28_28
25 күн бұрын
how hard was to install those , do you have to remove the swing arm ?
@WhiteRG24
25 күн бұрын
@@Garage28_28 Installation and removal again without removing the swingarm. The only thing you need to remember is to spread the glue on the bolts holding the axle/heat them.
@Garage28_28
25 күн бұрын
@@WhiteRG24 so it’s not necessary to remove the whole swing arm?
@WhiteRG24
25 күн бұрын
@@Garage28_28Yes, there is no need to take out the swingarm. Unless you've got a rig that's vintage and gets a lot of mileage, in which case it's worth checking the swingarm cushions. I, at my place, fitted this on an almost new motorbike.
@Garage28_28
25 күн бұрын
@@WhiteRG24 did those bushings help you out with the side to side sway at high speeds ?
@Roadmenace818
3 ай бұрын
Install vid ? Coming soon
@alloyartmfgco4716
3 ай бұрын
Yes . In the mean time Stefan’s Garage has a great install vid . instagram.com/p/C12sWJ9yZpz/?igsh=MzRlODBiNWFlZA==
@Roadmenace818
3 ай бұрын
Thanks. I did watch this video was hoping to see a different way but thanks
Пікірлер: 12