Thank you so much guys, you gave me exact the information i was looking for!!!
@MrElofix
3 ай бұрын
I would like to know why i have to cut off the rj45 connector and use the bms connector instead. In the byd battery manual there are two options. One with the rj45 plug connected to the can bus socket and the other option is the one you showed here. My problem is that i cant get the battery running. I always get a connection failed message when i add the HVS Battery in the app. Any ideas whats wrong? I would also like to know why there is no link for Firmware download on the Goodwe website....
@GoodWeSolarAcademy
3 ай бұрын
Hello, you may first check the version of firmware. If you don't know if it is the latest version, you can email us via community@goodwe.com.
@lillibillilli
Жыл бұрын
How to connect two towers HVM 22.1 to the GoodWe 25K-ET? All manuals only contain connection diagrams for connection one battery or more batteries in a row (Master-Slave). But this inverter has two battery connections - we would like to use them...
@dosso96
3 ай бұрын
I have the same question, did you figure it out please? Do you mind to share?
@lillibillilli
3 ай бұрын
@@dosso96 you have two options: a) using both BYD towers in a master-slave-configuration or b) using both BYD towers independently (both as a master). Power wiring (DC) and information wiring (RJ45 if I remember correctly) need to be consistent. In case a) both BYD towers need to have an RJ45 wiring and power wiring to each other (Master-Slave mode as described in the manual). In case b) power wiring goes directly to the inverters (twice), no information wiring (RJ) between both towers necessary (in fact it harms the setup). ... That's what I remeber, hope that helps. We figured that out ourselves, the support of goodwe unfortunately did not help us.
@KevinSturm79
Ай бұрын
Yes, correct. Since the ET25 has 2 independent battery ports, you can connect a HVM tower to each port and run them with each power lines and communication cables independently. Greetings
@sos4u
11 ай бұрын
thank you so much. do you have a video explaining the configurations on the Goodwe Hybrid inv? what each one means? SOC, SOH, Fast charge ect. ??
@user-ke9yk5qp3u
7 ай бұрын
I have the SolarGo app and it does not refresh at all. It shows a one time power output snapshot and then it just sits there and doesn't update. I installed the other app to monitor my "power plant" and that one crashes every single time. I installed the smart meter bur technical support cannot provide me a users manual or an installation manual and the app does not show any additional information. The technical support people talked down to me like I'm a dummy and interrupted me numerous times.
@reviewmirror
Жыл бұрын
Is 6mm² PV cable enough for HVM/HVS Battery and 8kVA Inverter? I am a bit concerned about this.
@YTCrazyObbe
3 жыл бұрын
What to do if I need to place the battery more far away then the cable can reach? Thanks
@stonemad2120
3 жыл бұрын
then you need to extend the network cable ,make sure the cable is long enough to connect the battery with inverter.
@user-mm5ww2mc6c
6 ай бұрын
Can you please add the service number (phone) for Switzerland/Germany? thank you!
@GoodWeSolarAcademy
6 ай бұрын
Hello, you may find contact info here.en.goodwe.com/contact-us
Пікірлер: 15