I found this engine advertised on the marketplace. A recent paint job covered a few unexpected problems that I missed upon initial inspection. Look them over good!!!!
Very nice! Looking forward to seeing the repairs and seeing this thing running again! :)
@jimmybritt9537
Жыл бұрын
People do crazy things but it keeps you busy 👍👍🇺🇸
@jackgreen412
Жыл бұрын
Good stuff!
@baynson3189
Жыл бұрын
Recently purchased a 1952(I think) FM Z engine. 7hp. I'm new to this hobby and looking forward to the experience. I'm a boiler man by trade but steam equipment is much harder to deal with without a nice boiler. So, gas engine it is for now. looking forward to part two...
@enjundoc
Жыл бұрын
Nice! Hope you enjoy Gas Engines as much as I do! It's a great Hobby.
@deanchapman4337
3 ай бұрын
I have the same engine and is been hard to find any information on it...I am trying to set the timing and dont know where to look for timing marks? There is none on the gears on crank shaft.
@enjundoc
3 ай бұрын
The easy way to set the cam timing without marks is to coordinate the opening and closing of the exhaust valve with the piston at tdc and bdc. Set the exhaust valve to open at or just before bottom dead center, and close at or just before top dead center. You can then set the spark to occur at around 10 degrees before tdc. Hope this helps. Thanks for watching!
@clarencetrice4442
9 ай бұрын
most of those engines the gas tank was in the base of the engine that was most likely rusted our a long time ago they either couldn't make a new gas tank or either didn't want 2 take the time 2 make a new 😮😮 alot of those old engines U have remake the parts 4 them your self 😊😊 many years ago alot of those engines were sold brand new at hard ware stores and the time they were being made tractors were just seeing light back and most tractors were just being made in the 191OS 😊😊 OMG 11 21 2O23
@clarencetrice4442
9 ай бұрын
clay might 😊😊 work I never tried it most people use babbitt Wright when pouring babbitt bearings U also have 2 pre heat the bearing halfs and the bearing beds U can't pour new babbitt bearings cold they won't turn out right 👉 😮 when U do 😊😊 OMG 11 21 2O23
Пікірлер: 9