Goofing around to see when my printer will give up the ghost.
700mms external, internal, 500 infill, 50K acceleration, 40 square corner. Cube section was in min layer time, so slowed down to 300.
ABS, 295C. 1st layer 200 external, 300 internal, goofed up and had gap fill at 75. Flow is too high and I have issues with retraction in corners. Probably just too fast? Hell no, gonna see what makes it tick or give up. Some VFA or ring on the top. Chube heavier, so over my limit? Might be in that motor resonance range.. probably what it is? Let's see..
Slow it down and it's cake.
Негізгі бет Gotta try just to see?
No video
Пікірлер: 14