I have to rewind one. Any pointer's? I think it's two times around.
@AbstractDreamz
19 күн бұрын
Great! Good thing that I got my cam installed tonight. Bad thing that I removed the wrong screw. Fortunately amazon has one getting here tomorrow.
@kennethharrison1233
4 жыл бұрын
What’s the size of the bolt you used to keep it all together?
@stevenzansant5645
Ай бұрын
Hey i have a question i bought a texas speed stage 1 cam it came with phaser delete wedge ...i took that wrong bolt all the way out heard it unwind put the wedge in and bolted it back up..do you know what would happen if i tried to use it?
@GwatneyPerformance
Ай бұрын
Best advice is to replace the phaser. Rewinding that spring is no fun.
@CamaroCade98
5 жыл бұрын
Putting the limiter in my old phaser when I did the SS3 cam was actually pretty easy to do a year and a half ago before I recently switched cams. It’s not a hard process to do.
@rkuper82
3 жыл бұрын
What foot pound do you torque the torx screws when putting it back together?
@pablo3735
2 жыл бұрын
Can I reuse the cam phaser bolt ??
@travispeoples
4 жыл бұрын
Is it the same process on a 2010 L99? Does the limiter go in the same slot inside?
@_simplynay
4 жыл бұрын
Any update on it?
@travispeoples
4 жыл бұрын
@@_simplynay it is the same... I just did mine. There is only one position for the limiter to go.
@_simplynay
4 жыл бұрын
Travis Peoples got mine from gpi 4 degrees, did you use the same one or the 0 degree, mine didn’t fit
@Izzy-nq1pk
4 жыл бұрын
4 or 0 degree?
@travispeoples
4 жыл бұрын
@@Izzy-nq1pk mine is 20° I have a picture of it on Instagram lq9_z71
@MWilk098
8 ай бұрын
4 degrees seems like it is pointless. the factory sprocket allows for 60+
@CSS_Fifty
10 күн бұрын
4 degrees of timing can make a pretty big difference. I prefer to just run the 0 degree limiter.
@anthonycasey6064
3 жыл бұрын
I bought you know most people can't use two hands at one time right 😆
Пікірлер: 18