I have used Trimble products throughout my military career, and you mentioned setting the Elevation mask for satellites at 10 degrees. We normally set the elevation mask to 15 degrees; however, we would lower the elevation mask to 10 or sometimes 5 degrees, especially in areas that enabled us to grab or use more data from more satellites if we were experiencing a lot of cycle slips or other interferences from some satellites that were skewing our data. Then I would disable those bad satellites from being used for processing, and use the available satellites that were in the range of 5 or 10 degrees above the horizon to potentially give us a stronger data network tie. If not we would run another session or two as necessary.
@JacquesTreehorn
Жыл бұрын
I thought Trimble DL stood for down load. Data Logging makes more sense. Been thinking that for 4 years. Been telling people to look for the app as Trimble DL and saying down load. I like it. It is faster than the wired data transfer app. You don't need the special Windows 10 usb to serial. Use Android with Trimble in general. iPhones wont take a beam from the TCS3s
@dicky161293
3 жыл бұрын
Mary and Mvil is the control point right? at the first base line process, why you set all of point as control? and after the process you decide the control point (mary and mvil). shouldn't it determined at the beginning before the process?
@dicky161293
3 жыл бұрын
i have some question, why you dont process at same time all of sesion on that project?
Пікірлер: 4