Going through some trials and tribulations with my Chinese mini excavator...
@mellyons4052
Жыл бұрын
How is it running? You happy with it so far ? We just bought Rhino xn12-9. But smaller. It should have arrived in Manila port today.
@torino2610
Жыл бұрын
it's running great, i did some drainage work so far, but stopped operating until i get the lubrication issues straitened out. overall i love it.
@mellyons4052
Жыл бұрын
👍🏽👍🏽👍🏽👍🏽👍🏽👍🏽
@rustyharrison1717
10 ай бұрын
I just bought an AGT H12 and was having similar grease gun issues. I had a standard zerk blow out of its hole, looks like it was cross threaded or more likely not a complete thread was cut on the female location. I bought the rubber tipped fitting to grease those flush zerks and the grease just short cuts out between the metal body and the rubber tip. Put on the all metal tip that came in the tool box, it now works fine. I purchased two guns, one for each type of zerk , as the flush ones require a ridged setup and the regulars can use the flexible hose. I thought setting up the new guns to grease all the zerks would take a half hour, it took all morning and the fittings at the back of the blade still don’t work.
@torino2610
10 ай бұрын
@rustyharrison1717 i did a "winter-ization" on mine and had to replace several male zerks that were clogged or just bad from the factory. after switching out the zerks i got good sqweeze out. the female zerks are good if using the metal needle attachment. yes, took me hours to grease the first couple times, until i got the zerks sorted out. im actually wondering if its possible switch all to the female low clearance fittings...
Пікірлер: 6