Tap racked in this drill with a handgun and ended up with the dummy round backwards in the magazine 😭
@2AlphaTrainingGroup
3 ай бұрын
Not sure if that impressive or unfortunate
@juanmanuelalonso8907
5 жыл бұрын
good information
@2AlphaTrainingGroup
5 жыл бұрын
Thanks!
@the_lippmann
3 жыл бұрын
dont be limp wristed. check.
@GhostShura1984
Жыл бұрын
I had 7 stove pipes on a brand new gun
@2AlphaTrainingGroup
Жыл бұрын
That might be a guide rod spring issue. Aftermarket?
@GhostShura1984
Жыл бұрын
@@2AlphaTrainingGroup it’s a Springfield ronin 10mm the extractor is broken -after comparison with other 1911 the extractor claw you can see it’s missing - even cycles by the rounds they don’t fly out they just pop up slightly - I was told to send it to the manufacturer-
Пікірлер: 8