it ends at Bwlch Penbarras, but where does it start?
@neilflowers2893
Жыл бұрын
Hi it starts in mold
@thomasboffejon6518
Жыл бұрын
Nice video man ! Might order one tomorrow 👍is that a 13t sprocket you went down or 12t ? Easy to decat the pipe, right before the slip on right (noticeable perf increase and any louder) ? Last question, are these the acerbis x factory handguard you have on ? Mine will be 2021 model what about yours ? Thanks enjoy the ride ✌
@neilflowers2893
Жыл бұрын
Yes 14 tooth mine was a 2019 Yes decat is very easy just 3 tiny spot welds it is louder but makes a big difference
@thomasboffejon6518
Жыл бұрын
@@neilflowers2893 thanks for the answer ! Was it lot louder or still ok ? Any other mods you did to tune it a bit more ✌ you have a crf300l now i saw in your page .?
@neilflowers2893
Жыл бұрын
Just louder nothing nasty. I didn't do anything else to it for the type of lanes I ride it was fine I'd say the only down side to the bike was the suspension but cheap bikes have poor suspension.
@thomasboffejon6518
Жыл бұрын
@@neilflowers2893 thanks for the input. As long as you don't take 2m jumps they should be fine I guess 😂 Can't wait to order mine tomorrow ✌
@slugslugster9338
2 жыл бұрын
have you reduced the front sprocket by 1?
@neilflowers2893
2 жыл бұрын
Yes I did it made a big difference. If you remove the cat as well it runs so much better.
@kill6894
2 жыл бұрын
is it a good bike I am thinking to buy one?
@neilflowers2893
2 жыл бұрын
They are good for the price but you will have to change the front sprocket and the rear shock and the fork oil to get the best out of it
Пікірлер: 11