Looks good, the grill is the hardest part, it’s the first thing people see. I am worried about your splash guard. On the bottom of your shell, there is a splash guard that runs from front bottom to bottom of the radiator support. It looks like with all the welding and bending on the nose you may have warped the mounting holes for the splash guard to fit.
@Nelsons-Garage
6 ай бұрын
You would be correct, I haven’t started finishing the inside of the shell yet. But I’m thinking of eliminating that lower deflector and put the transmission cooler in its place. I realize the air flow for the radiator will be compromised but I think with an electric fan setup it should be good. Of course I might change my mind…
@mikethespike6304
6 ай бұрын
Wow lots work there . I have to ask Do you think you'll have it running this summer ? Hey thanks your input on my Plasma cutter I talked with customer service at Hyper Therm and they said unplug the fan and see if it came on ,, That was a no go so it's the mother board and now it's headed to the repair shop .. Keep on going !
@Nelsons-Garage
6 ай бұрын
Not this summer I'm thinking a couple years yet. I don't work on it every day and i will be busy enjoying the other car through the summer. But I should be starting body work soon. Too bad about the plasma cutter, but I'm glad it will all work out...
@RexHuha
25 күн бұрын
Where can I get some other kind of clips to hold molding on around grille?
@Nelsons-Garage
25 күн бұрын
Not sure what clips would work other than originals, that is why i used screws. not sure if that will be my final fastener, but if i can find something else I will show it in my future videos.
Пікірлер: 6