To do a head gasket job in a 6.2 or 6.5L diesel it is best to remove the engine. That way you aren’t cramped in an engine bay trying to prep critical surfaces.
You will need:
New heads or get your originals machined and checked for flatness
M12x1.75 clearing tap
Green scotch bright pads
Brake clean
Shop towels
Permatex high temp thread sealer
Rubber mallet
19mm deep well 6 point socket
Torque wrench that goes 50-200lbs
Haynes manual or the correct torque sequence printed off
Torque to 120lb-ft to prevent future head gasket failures.
Негізгі бет GSC 6.5L Head studs install tips and tricks walk through. More info in the description
Пікірлер: 23