Hello B.A. , I notice your lock nut is on the wrong side, according to the workshop manual, mines is on the otherside. I lift my bike on my Abbastand at the swing arm and adjust the chain, 20mm to 30mm I am going to double check my workshop manual but sure it didn't make any fuss of the bike being supported with its weight on a paddock stand. Bike down on the ground it's absolutely fine. Use your torque wrench Sir 100nm, always best. 👍
@bikerantics5001
Ай бұрын
Hi, I’m gonna do a video about this comment soon 👍
@blackdotkiller1
Ай бұрын
Nurse nurse he's out of bed again, and now he's been reading books 📚 🤦♂️🤣
@bikerantics5001
Ай бұрын
. . . and still he knows nothing🤷♂️
@mickusable
Ай бұрын
For the tightness on my rear spindle, I usually tighten it VFT if that helps and it’s never come loose 🤘
@bikerantics5001
Ай бұрын
I used to but couldn’t afford to replace all the wheel bearings more often🙄🤣
@deniskennedy9070
Ай бұрын
You can get carbon fibre cover for fount hangers it sticks on, paint will wear of with your boots.
@bikerantics5001
Ай бұрын
I don’t really like the carbon fibre look and I was thinking of getting them powder coated, not a quick rattle can job by me😂
@WEGGYZZR
Ай бұрын
See I adjusted the chain on my gen 2 the other day for the first time and only have an ABBA stand so did mine old school on the side stand with wheel in the floor obviously utilising the compression associated with the bike .. My axel nut is on the right side btw ... Adjustment I like to get absolutely spot on but used the markers on the swing arm this time and for a change they are pretty much on the nail... Tightened to spec torque settings of 100nm which to the hand felt spot on also ... New bike to me and the chain and sprockets in top condition so no need to go and empty my beer money jar yet...
@bikerantics5001
Ай бұрын
@@WEGGYZZR 👍now go out and have fun wearing it loose again👌
@markstaley5922
Ай бұрын
I would think they’ recommend the paddock stand for safety reasons I can’t see any difference in swing arm travel ether 👍
@bikerantics5001
Ай бұрын
It weird that it’s the same bike just different generations 🤷♂️.
@bizman185
Ай бұрын
I did this with my bandit 1250, overtightened without torque wrench, gubbed the thread realised 100nm is less than I thought. And yes I also had chain tightness carry on too
@bikerantics5001
Ай бұрын
@@bizman185 isn’t the chain tightening itself fun🤬 😂
@darrenmilo9565
Ай бұрын
I said black before you said it so obvs yes.
@bikerantics5001
Ай бұрын
Obviously 🤣
@MRTPR
Ай бұрын
I checked my bible and couldn't find anything regarding the chain on a Hayabusa. 🤣
@bikerantics5001
Ай бұрын
@@MRTPR was it the Old Testament or the New testament ?
Пікірлер: 18