This is looking great. Subscribed. I've done my gs750 as a cafe racer and always wondered about doing the front end swap. Keen to see how it turns out.
@wayne3340
Ай бұрын
I can see in your video, there are three slots around the upper race. Put a chisel in there at an angle and break the outer race in pieces.
@timhorsley7367
2 жыл бұрын
So sick Benj! Always look forward to your uploads
@Benji...
2 жыл бұрын
Thank you bro!
@mario_on_e-odin2.0
4 ай бұрын
I have never do this so sorry for my dumb question - what is that conversion stem kit for ? To get front part higher ? If not could you use original stem (with proper bearings) ? Thank you. Subscribed.
@Benji...
4 ай бұрын
you may be able to just use conversion bearings I'm not sure
@user-hi7im4pi1f
Жыл бұрын
What size is top bearing
@jakeanico9642
2 жыл бұрын
What size is the front axle rod on this one?
@Benji...
2 жыл бұрын
25mm
@jeremypena8935
2 жыл бұрын
Will gsxr front end will fit my 78 xs750?
@Benji...
2 жыл бұрын
Sorry i don’t really know those bikes bust i’m sure it would, just need to find the right conversion kit or bearings needed
@thefacilitysportstv8127
2 жыл бұрын
How long is the conversion kit stem? Looking to do the same on a gsx1100g
@Benji...
2 жыл бұрын
It's quite long, longer than the GSXR stem and I had to use a few spacers on the bottom as you can see in the video
@thefacilitysportstv8127
2 жыл бұрын
@@Benji... thanks for the response! That’s good to know, I was worried it could be too short, sounds like it’ll work
Пікірлер: 15