In this video I cover a detailed install of the Track Nanny, the GPS based exhaust valve controller for your Porsche. This install is done on my 718 GT4 but I address the differences with the 981 GT4. The install is straight forward but it does take some time to get to the engine as many trim pieces need to be removed. After we connect the Track Nanny and get it powered using the fuse tap, we test it out to make sure it works. You won't find a more detailed video on removing the rear trim pieces.
00:00 Introduction
00:38 Track Nanny Basics
02:42 Tools Required
03:30 30 Second Overview
04:04 Accessing the Engine Bay
08:29 Connect 718 Wiring Harness
12:10 Connect 981 Wiring Harness
12:39 Install Fuse Tap
14:31 Testing Operation
16:07 Closing Up the Engine Bay
18:45 Conclusion
Learn more about the Track Nanny from Tom who makes them:
• Porsche too loud for t...
See the Track Nanny in action at Laguna Seca:
• Will the Track Nanny S...
Buy the Track Nanny from Tom after joining and contributing to the Carpokes Porsche Forum:
www.carpokes.com
Tooks used in this video:
Plastic Trim Removal Kit: amzn.to/3zrCGTV
90 Degree Driver Adapter (cheap): amzn.to/3b2ySPt
90 Degree Driver Adapter (better): amzn.to/3zoVpPW
Low Profile Ratchet and T30 Torx: amzn.to/3OpAoZz
Dewalt XR Impact Driver: amzn.to/3v9wRYN
Jet Fuel only is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com
Негізгі бет Автокөліктер мен көлік құралдары GT4 Detailed Exhaust Valve Controller Install: The Track Nanny
Пікірлер: 13