In this video, I will show how I grind guide feet. Guide prep is an important step in the rod building process. If you do not grind down your guide feet, it will make the thread transition from the rod blank onto the guide much more difficult and will usually result in a cosmetically flawed area on the rod. I grind my guides on a lathe using a diamond wheel, running at 600 rpms. You can also use a drill or a drill press and get the same results. I go over some possible ways to go about doing that in the video. I will also show you how I like to finish off darker colored guides after grinding. I hope you enjoy the video and please feel free to leave any questions, comments or suggestions in the comments below!
All of my links (my store/social media/email information) are here: linkpop.com/5286af
Негізгі бет Спорт Guide Foot Grinding - What I Use To Grind Guide Feet And Finishing Touches
Пікірлер: 19