When you build these Guillow's conversions (especially the P-51), do you change the motor's thrust angle from zero? Some builders recommend a couple of degrees down and a couple degrees to right for motor thrust.
@jagdpanther9
2 жыл бұрын
Yes i add a little down and right thrust. You really tell when going into full throttle from crusing speed.
@PS-rr2jt
7 ай бұрын
Did you add washout and dihedral to the wing? If so, how much of each? Beautiful job!
@jagdpanther9
7 ай бұрын
Thanks. With this model i built ithe wing by the directions for rubber power.
@MORCOPOLO0817
Жыл бұрын
Have you done a Chipmunk yet?
@jagdpanther9
Жыл бұрын
Not yet but i have considered it
@brohoop
2 жыл бұрын
Another great one! I was always told monokote would warp the crap out of these little stick models when you heat shrink it. No?
@jagdpanther9
2 жыл бұрын
you need to watch it with monokote. i have used it to my advantage and added or subtracted wash out with it. it is really easy to use once you get use to it and how much heat to put to it.
@brohoop
2 жыл бұрын
@@jagdpanther9 good to know. Thanks!
@lilgreencanoe2936
7 ай бұрын
What motor? 😃
@jagdpanther9
7 ай бұрын
Motor and brick from a park zone j3 cub 😎
@stevejohnson3991
Жыл бұрын
Beautiful little plane! Nice flier too. What was the total weight w/battery?
@jagdpanther9
Жыл бұрын
Thanks! This model weighs 2 1/4 ounces.
@RealSamuelMach
2 жыл бұрын
Are you in Arkansas?
@jagdpanther9
2 жыл бұрын
Im in southern minnesota.
@RealSamuelMach
2 жыл бұрын
Oh looks warm
@Justwantahover
2 жыл бұрын
Not a super Cub. It's a Pacer.
@pointerstep
2 жыл бұрын
No it is a super cub. The kit is based off a pa-18
@balsachopper7
11 ай бұрын
It is based off the PA-18 but the fuselage is actually too wide for a Super Cub. But who cares. It is not exact scale, it is fun scale. Have fun with it.
Пікірлер: 22