This video was very helpful and for your issue with sliding. I added 3M stop skid tape on both sides of the Ramp/Stops and that has made the dolly secure. I was able to walk my Harley up on the dolly with little to no effort. Thanks
@rickoliver5684
Жыл бұрын
or bolt or glue a thick rubber piece of mat or trucker mud flapp
@webadage
2 жыл бұрын
I bought one of these three years ago and only now am I putting it together. I used your video as instructions because I can't find the instruction manual. LOL. The way I plan to remedy the roll away bug is drill a center hole and permanently anchor it on a pivot in the floor. I park my bike in the house and that's the only use for that room. Ride in, park, pivot, ride out. :) Thanks for the video instructions.
@SportbikeUnitedRiderz
4 жыл бұрын
Thanks for video; think I'll use your guide to complete my when it arrives.
@JamesDavis-qs5ni
Жыл бұрын
OMG! I wished I had viewed your video prior to trying to load my bike. I had the exact same issue and ended up laying the bike on it's side. Pulled a Hammy trying to hold up my Street Glide by myself while the bike was half on the dolly but it moved. They need to add additional wheel brakes. It can be dangerous. Thanks for the video.
@ghostpepperrides4805
5 жыл бұрын
I have needed one yet. But have a number of friends who love them.
@jairjosedrummond7557
2 жыл бұрын
Great job and thanks so much !!!
@MotoPappy
5 жыл бұрын
I own that model of dolly and have the same problems with it not staying in place. It’s not the best dolly but gets the job done.
@cheezehdglen9468
2 жыл бұрын
Sold me...Just went and bought mine. Can't be beat for $99
@mrnoedahl
3 жыл бұрын
Great video my friend. I just put mine together after watching you. Unfortunately my bike is a tad too long, and the kick stand goes out too far. Guess I’ll be selling it on Craig’s List. I have a 2007 Yamaha V Star 1300.
@jacquestardif5848
5 жыл бұрын
Great job on the video. Would like to see a version that would have a wheel choke that could keep it locked in better.
@waynemiller6070
4 жыл бұрын
It does. But big bikes like this are a bit long for it. There is a rod for each end of the dolly. I only use the front one. And I leave the bike 1st gear.
@TexRider
5 жыл бұрын
good job bonz
@Angel75c
3 жыл бұрын
The little ramp at both ends is designed to lift the dolly up off the wheels so it doesn't move when you ride onto it. Put the handle down on both ends then try driving up onto it.
@cbonz7734
2 жыл бұрын
Nope, did the same thing.
@michaelfrascati7610
Жыл бұрын
@@cbonz7734 I believe the problem is a slippery floor. Maybe try something to rest grips of the ramp on. Maybe those adhesive tread gripper things (tape)at HarborFreight that are used on steps or ramps!?
@casperaudi7476
3 жыл бұрын
Thank you so much now I know who to set it up one little problem is but it’s not your problem is I have a long drive way so I know I have to put something under the wheel of the dolly from moving . Thanks
@garycrumrine9538
Жыл бұрын
The design is for you to flip the stops in both ends so it lifts the 4 wheels off the ground. That should allow the weight of the whole dolly to stay in place by the friction. Then you flip the levers again to drop it back on the wheels and roll it away. I hope that is how it works. Still waiting for mine to come in.
@Shadow0fd3ath24
2 жыл бұрын
You were about 2 inches from the kickstand folding and the bike falling off at 13:55 😱
@ctguy1955
5 жыл бұрын
At 64, the 2016 103 FLD gives me weight issues if I tip the bike over too much with the bar turned to the left. I have a 08 SP1200L that I can pick up off the ground and stand it up, and because of the weight, She is easy...…….. I have a 10 x 16 foot shed, and getting the two bikes in is a pain. I saw a video where a dolly bearing that was good for 1K pds and only 12 bucks, would be my best bet? two berrings and a 16' 2 x 10 cut in half and a few nuts and bolts wont cost 160 bucks as two of Your HF dolly. I know in your case, You wanted to move it over against the garage wall, but I can drive in either bike at an angle and do a 180 and park it. I would like to know your thoughts and I liked the video, well done !
@dwaynemorris2223
5 жыл бұрын
you have to have the front swing arm down also for it to not move. Haven't had any problems with my 16 ultra classic on it.
@harleynut1961
5 жыл бұрын
Tried this with mine, no difference , still moves.
@cbonz7734
2 жыл бұрын
I discovered when I moved to another house with a slightly rougher concrete floor it didn't do it. So my guess it slides easier on very smooth concrete.
@winteromara7702
5 жыл бұрын
Put a couple self tappers in the bottom of brake system for an extra 1/4 inch so it doesn't roll
@robdedgar
4 жыл бұрын
On my harbor freight dolly it looks like my new low rider is leaning over too much. Do you notice extra lean with yours?
@773reynaga
Жыл бұрын
Two rubber door stoppers will keep it from moving.
@rahoffman123
5 жыл бұрын
That's what I was afraid of it moving when you try to go up ramp what I came up with solution put rubber under ramp so when front tire roles onto to ramp rubber catches floor keeping it still
@cbonz7734
5 жыл бұрын
Tried that, just tore up the rubber after a while.
@rahoffman123
5 жыл бұрын
Oh I see wow their has to be a way not leaning up against wall
@keithfoxinc
4 жыл бұрын
You didn't have the front skidplate/stopper down - that's why it slid out
@dwright361
3 жыл бұрын
yep
@cbonz7734
2 жыл бұрын
It did it both ways.
@Cerebrum72
5 жыл бұрын
thank you so much for the video. how wide is this? I have a HD With rear tyre 240/40-R18, can it fit? Thnx
@cbonz7734
5 жыл бұрын
My tire size was 180/65 X16 and that was probably maxed out so your width probably will not fit
@davemorton7988
Жыл бұрын
Is it the 94 inch one
@davidalexander1946
5 жыл бұрын
I have a problem fitting the kick stand on my Road Star. It's too long.
@russellberry9156
3 жыл бұрын
Same problem for me. Kickstand is longer than outrigger tray and i must TIP (off balance) to right side to get kickstand down and up
@whocares0692
2 жыл бұрын
Can you change the casters to locking casters to hold it from moving ?
@cbonz7734
2 жыл бұрын
I went to a smaller bike that doesn't do it. I'm sure though your idea would probably work.
@OcotilloTom
3 жыл бұрын
My dolly manual say's NOT to ride the bike on or off the dolly. Maybe that's how "they" at Harbor Freight solved the problem.
@davidriegner2967
4 жыл бұрын
I have two of these dollies and neither slid when both of the ramps are down. Look at the video and you will see the front ramp is up.
@cbonz7734
2 жыл бұрын
Nope, did it both ways. Didn't do it when I moved to a house with a slightly rougher concrete floor however.
@ghostpepperrides4805
5 жыл бұрын
I noticed the kick stand moved back when you push bike around. Anymore bike would be down.
@cbonz7734
5 жыл бұрын
It does move a bit but the bike doesn't move enough to be a problem, just be sure it's in gear.
@harleynut1961
5 жыл бұрын
These do need some mods , I think the kickstand moving could be fixed by adding 2x4 to front and back of kickstand, once bike is parked you have your kickstand location.
@butteredbiskit3497
5 жыл бұрын
so your car goes in too! how wide is your garage? mine is tiny.
@cbonz7734
5 жыл бұрын
About 10"
@butteredbiskit3497
5 жыл бұрын
@@cbonz7734 I wedged my scooter into the corner so I could get my truck in from the snowstorm. As I saw you pulling your truck in I was ordering the dolly.😁
@ad78
4 жыл бұрын
The front is not properly engaged that is why it slides..
@russellberry9156
3 жыл бұрын
I have this dolly. I have 2 ‘82 FLT’s. Neither sits stable upon it And neither kickstand will fit into the outrigger tray.
@hcdigitalart
5 жыл бұрын
Watch my video on how I combated this issue
@richardkelso9478
Жыл бұрын
Link?
@OldBiker54
5 жыл бұрын
get bigger dollie wheels with the foot brake
@slyguyaction
5 жыл бұрын
Damn if you don’t need a workbench and a rolling garage chair.
@cbonz7734
5 жыл бұрын
I've since moved, have both now!
@markwalton16
3 жыл бұрын
This dolly from Harbor Freight won't fit a Indian because of its longer wheelbase.
@jwayplay
6 ай бұрын
Your bike moved on the stand when you demo'd pushing it around at 13:55. That could ruin your day. Ever cause a problem? $90 about 5 years ago. Now it's $130. Let's go Brandon!
@cbonz7734
6 ай бұрын
Never caused a problem and while I demo'd the push around typically I was way less extreme.
@ChrisLonsberryMedia
5 жыл бұрын
If you wheelie the front of the bike onto it..... just sayin'. Problem solved. ;-)
@japlunkett6789
2 жыл бұрын
Seems to be too much bike for you, man.
@flyingdog1498
4 жыл бұрын
The stuff in the rest of the world is Metric.
@shivdog04
2 жыл бұрын
Bro, you doing to much….. you didn’t have the front lever forward when you first attempt. You need to watch your editing.
@leslierhein3805
2 жыл бұрын
I tried it with the levers in both positions and it still did it. It was only cured when I moved to a home where the garage had a slightly rougher floor.
@rahoffman123
5 жыл бұрын
Own a harley bit drive a Toyota I hope you ain't that one who runs they mouth about bikes that ain't harley
Пікірлер: 66