Basically if it takes a while for your carb bike to start, most chances are you need to readjust your float bowls and/or rebuild your float bowl valves. If you need to turn you fuel tap in the off position overnight to get it started in the morning probably means your float valves are set to high and/or float valves are worn out and flooding your cylinders with gas. That’s why if you left the fuel on the “on” position you gotta keep cranking it till it burns through all the gas. In simple terms take your carb out, clean it and inspect your pieces, check if your measurements are within spec, if necessary rebuild it and you’re a pro synchronize them as well (of course only necessary if you have multiple cylinders) . That way you can always leave the fuel tap on and it’ll start up every time.
@KETEMEME
Жыл бұрын
For someone who is a complete noob with carburetors and engine idle switches. Can you explain how to properly use the switches as a daily commuter rider. If I ride for 5-10min and then hop off for quick errands what's the best way to keep the fuel clean and ready. Following the video is great for overnight park ups! Cheers!
@sonnyhylleberg1124
Жыл бұрын
YOU!!!! YOU.... Yout just helped me more than the ENTIRE internet! I have had problems with starting my Virago when it is cold for AGES! You trick... solved the problem no one else could answer! Thank you!! #everydayheroes
@loshonorables6165
Жыл бұрын
Awesome!!
@gta_content_loading8268
2 жыл бұрын
Thank u for this tip man! I’ve been having problems lately since it started getting colder here I’ve never had a problem in the summer but now it’s a whole different story I’ll definitely try this!
@williammoore6952
2 жыл бұрын
Going to give this a try. Thanks for the video!
@rayslife4k
9 ай бұрын
That’s great I’m definitely going to run out of gas before I park it at the house and then turn the Peacock on like you said before I started in the cold today I did not wanna start after like six or eight cranks I was getting scared that I was going to kill the battery sometimes when it did start it will turn off right away. Thank God it stayed turned on.
@dewdrop3009
2 жыл бұрын
Oh I knew about the petcock and the turn it off but I've always turned it off after I killed the bike. I'm going to give it a try for my 1978 CB750 K. Another tip that used to help is by putting the heater on both sides of the engine to warm it up before startup. I try not to blast high heat, but keep it decently warm and to let it warm up for about 30 minutes
@schlumberger112
3 жыл бұрын
Thank you, will try this out on my evo fxd
@vsopphoto
4 ай бұрын
thanks for this! I've been wondering why my bike's been slow to start recently, but runs totally fine. I'm new to riding and had been leaving the petcock on because nobody told me I should turn it off, let alone let the bike burn up the excess gas in the carb before shutting it off. I'll definitely try this and see if it helps!
@sijonda
Жыл бұрын
Having a hell of a time looking for why I'm having an issue getting my bike to start when cold out. Now when I'm specifically saying cold, I mean like right now (I'm in PA). It starts fine in the spring, summer, and fall. It's usually an issue when it's below 50 or 55 out. So i know it's not the same issue you're referencing here. If I could reach the intake with my hand to further choke the air, I would.
@bitcoinronin7459
10 ай бұрын
bro, i never knew, thanks for posting
@scottmiller4034
2 жыл бұрын
It has nothing to do with moisture building up in a carburetor. If you had hard starting problems that required shutting off the fuel petcock overnight you most likely had a needle and seat that was leaking or a float problem and it was flooding the engine. However, it still is not a bad idea to shut off the petcock just in case the needle and seat fail (if your bike`s petcock has an off position - not all bikes do) !
@user-jk3dz2st7u
2 жыл бұрын
You are definitely wrong my bike cold starts perfectly but today the humidity was so high that the whole motorcycle was wet without any raining . It took a lot of cranks to start and it was a humidity problem 💯.
@chaddotter8691
Жыл бұрын
That makes a lot more sense I've never heard of a carburetor building up moisture overnight unless you lived in the tropical rainforest
@nigelemmanuel701
2 жыл бұрын
Thanks alot this really helped me.
@loshonorables6165
2 жыл бұрын
Thanks for the feedback
@annihilationcontrol6369
3 жыл бұрын
Damn good idea bro, will try that out
@loshonorables6165
3 жыл бұрын
Let me know if it works for you bike.
@stumpyhobbit2175
Жыл бұрын
I have just had my carb cleaned a few months back but before then it was a bitch to start in winter, I will give this a try for sure as I need the bike to get to work at 5am in freezing conditions sometimes...edit....after doing this during winter my bike has started everytime, I wish I had known it sooner.
@obeyroy13
2 жыл бұрын
Love you bro.
@leonardfranklin4634
3 жыл бұрын
You aren't worried about drying out your seals?
@z1officialentertainment651
Жыл бұрын
thank you 🤯
@marvinrodriguez4071
Жыл бұрын
I have hard time to get start my Honda shadow 2002 winter months below 50’ I will try this
@whatisdreup2
2 жыл бұрын
I think that drz had the petcock swapped. Mine doesn’t have that option unfortunately but it always starts easily with the choke on
@loshonorables6165
2 жыл бұрын
That could be the case. Yes
@IPCRo
3 ай бұрын
What if I have a vacuum and manual petcock?
@RT22-pb2pp
8 ай бұрын
Never had that problem on my 85 ninja 600 with carbs but then mine was always tuned right carbs adjusted synced and no problems. All they way until I sold it 6 yrs and 60k miles later started fast easy every time. maybe if you have starting problems bike is not tuned correctly
@oldschoolmotorsickle
Күн бұрын
If you’re going to do the float bowl trick, just shut the petcock to off a couple blocks from home. It takes bloody long time to drain a float bowl with the bike running at idle, meanwhile stinking up the joint and pissing off the neighbors.. The trick only works on true manual petcocks though; if your bike has a vacuum petcock (with a “Prime” position) and no dedicated “Off” position, fuel will continue to flow with the motor running..
@marviricrivera3961
Жыл бұрын
My Yamaha vstar 250 only have RES, PRI, ON and every morning I'm having a hard time to start my bike ano tips
@eLu2198
5 ай бұрын
How about if we own a different bike i.e. suzuki bandit in my case? Cause if i let my bike parked for a couple of days, i have huge difficulty starting it up in the cold days.
@loshonorables6165
5 ай бұрын
Try it . It should work
@motormax6048
2 жыл бұрын
After you turn the fuel on don’t start it straight away let the carb bowl fill up first
@loshonorables6165
2 жыл бұрын
Yes
@gerd5493
4 ай бұрын
Isn't that the same as using choke? You're enriching your air to fuel ratio when starting
@jasonaa8992
3 жыл бұрын
Right now it’s not in the off position right? The horizontal position on my bike is the “pri” position. Correct me if I’m wrong
@loshonorables6165
3 жыл бұрын
It also depends on the type of petcock. this will not work on some of them.
@jasonaa8992
3 жыл бұрын
@@loshonorables6165 ok I’ll give it a try. Thanks a lot
@Wicker888
7 ай бұрын
So i did this and now it has loud explosions from a katana 750.... i drowned it how can I undrown lol?
@Mediterranean.barber
2 жыл бұрын
I will try that today on my cruiser i struggle to start it 😫
@alaricace8118
Жыл бұрын
Did that worked?
@kalanidodd9682
2 жыл бұрын
But mine doesn’t have an off. Only PRI, on or res
@spaguru
6 ай бұрын
It's fuel injected....
@Bishop760
Жыл бұрын
What does RES and PRI mean?
@Dar7635
Жыл бұрын
reserve and prime....Mine's like that so I don't think this video can help
@Ayaz_Qais
2 жыл бұрын
Not all bikes have this knob, what to do with them
@Kestrel16C
2 жыл бұрын
If your bike doesn't have one it's probably fuel injected, so it shouldn't matter to begin with.
@motormax6048
2 жыл бұрын
@@Kestrel16C no it’s probably got a vacuum pump
@Ayaz_Qais
2 жыл бұрын
@@motormax6048 yes maybe it got vacuum pumps, any tips to start it easily without many cranks. Thanks It’s 2016 hyosung 125cc
@joecamel6835
2 жыл бұрын
There's no off on mine.
@mohammedhegdah
2 жыл бұрын
With the current hike in gas price, am afraid that's not a good solution
@rustystubbs242
4 ай бұрын
It’s a jetting issue. ie: too lean due EPA emissions regs. I have an older pre emission regs machine and it starts great.
@elixier33
2 жыл бұрын
Alternatively just pull the choke down for a few seconds really not a problem or a big deal
Пікірлер: 53