Very nice work. I wish I could get my lathe bed resurfaced. I not brave enough yet to attempt it. He he
@jacobpace4716
Ай бұрын
fantastic workmanship! i wish i had the machine for this type of work! well done.
@bardmadsen6956
22 күн бұрын
I'm curious as to set-up, long ago I ground aircraft cranks, hot rods, to large diesels, then over the decades I taught myself machining by collecting. This is the first video that, as far as I can see, is holding the work as I think it should be done, correctly. I have a planer and mill, both 1x1x3 feet envelope. I would assume that the bottom of a lathe bed would be alike the centers on a crankshaft and possibly held downward without distorting the work, loading, but most other objects should only be trapped horizontally, floating, with minimal downward force. And, place shims in places not in contact with the platten. Is this generally how it is done? Just watching reminds me of the boomerang kid on Mad Max wanting the music toy.
@technicalboy5730
21 күн бұрын
Wow good job
@barnaszabo7222
11 күн бұрын
Hi, nice work. Can you tell me please the type of first grinding wheel?
@lypsvago
21 күн бұрын
Wow
@laurentl3064
24 күн бұрын
Bonjour bravo pour le travail je voulais savoir combien ca coute ?
@user-yd6lg4xp6d
29 күн бұрын
С СОЖ ещё лучше
@mapstardamo1624
23 күн бұрын
I have the same lathe and was thinking of a regrind. Lovely work. Where are you based
@joecorner8974
23 күн бұрын
Near Burton upon Trent, Staffs
@taffbats
24 күн бұрын
Hi Joe I have the same lathe, i was wondering whats a rough price to have this done?
@joecorner8974
24 күн бұрын
Hi, for all work shown (bed, saddle & cross slide) £750+vat
@taffbats
24 күн бұрын
@joecorner8974 do you add turcite to make up the difference? Thinking of apron, headstock and tailstock. Or would that be on me to shim?
@joecorner8974
24 күн бұрын
@@taffbatsIt depends, this machine didn't need a lot taking off so didn't warrant the additional expense, its not recommended for tailstocks, better to shim,
Пікірлер: 14