Hello, and thanks for the great tip on riveting the unreachable curves on the fuselage using transparent tape and the riveter. The translation is great, and I dont really pay much attention to the typo errors / misspellings. Have a nice day, and thanks again :-D
@Yow-ske
9 ай бұрын
Thanks for your comment. For areas where large rivet rollers cannot be used, such as fillets, I am following this procedure. I hope the model you create will be even better♪
@vmoney9106
2 жыл бұрын
Translation was great , I understood everything. You tips on using a compass and the tape are great, I will have to keep those in mind when I work on my next build (1/32 Ki-84 prototype). One tip about the rivets not meeting at the spine and belly of the fuselage would be to draw the lines on both halves first, then put them together to see if they meet before you rivet one side. I found this is also important for the wing leading edges.
@Yow-ske
9 ай бұрын
Thank you for viewing. You are right, when riveting the back and belly, roll the rivet roller with the parts aligned on the left and right sides to prevent them from shifting. It would be a good idea to follow the same procedure for the frame lines of the main wing ribs.
Пікірлер: 4