Check-out all the other D-Max content here -> kzitem.info/door/PLloptHW8MGGhzVQRkJaMUeCIUh5ZEplfB
@MattMills-gz6nx
Жыл бұрын
A no nonsense commentary giving clear instructions and lots of detail all one handed and in a pair of Japanese safety slippers. Made my job easier, well done!
@VideoShowMeHow
Жыл бұрын
Safety first 😁
@nickk5731
3 ай бұрын
mate been watching your vids for few months and just googled hayman reese controller and your vid come up. Mate love the way you go through all your installations. Clear precise and not make it complicated. Im ringing up tomorrow to get torque locker off those blokes you mentioned because of your vid not long putting one these in. Yeah they heaps better, especially towing. Loved to shout you a beer mate
@VideoShowMeHow
3 ай бұрын
Thanks 👍
@nickk5731
3 ай бұрын
@@VideoShowMeHow are you still running patreon? I went to join but cant get it to work
@VideoShowMeHow
3 ай бұрын
@nickk5731 no, but have KZitem memberships, use the 'Join' button if you're keen to check it out 🙏
@nickk5731
3 ай бұрын
@@VideoShowMeHow ok will do. Yeah appreciate your vids
@VideoShowMeHow
3 ай бұрын
No worries, enjoy 👍
@adamhergert8362
5 ай бұрын
Thanks for the video Adam - this inspired me to install the same kit into my 2023 MUX... thinking it would all be pretty much the same... but I came across a few differences. One is that the console buttons are different - Isuzu opted for custom sized, asymmetrical blanks, so you can't swap buttons side-to side. They also opted for a really long microswitch board under the right side cluster, which meant I was limited to where I could put the dial control. A bit of careful dremmelling, though, and that is all in. Your guidance on a couple things was spot on, like 'put a little nick in the firewall gateway boot'. Def so not take it off - real pain to reconnect it! I also ran the wires all under the car, so put them in a 9mm split conduit - seems to be generally recommended practice. Cheers, Adam
@jasonknox1926
2 жыл бұрын
Brilliant and very thorough installation guide Will be following this to the letter when I order my brake controller Keep it up!
@jedsack58
6 ай бұрын
Great video. But do you have a video of how you fashioned the switch blank to fit the dial. I struggled to get that bit to fit
@waynegale825
3 жыл бұрын
Thanks Adam, have been looking at brake controllers, was thinking about Redarc, but after seeing your set up I have change my mind. Will definitely go with Hayman Reece and set up the same, I really like that centre console idea instead of a mount that is difficult to see and locate at times. When you think about it, we all should do similar if possible. Thank you
@VideoShowMeHow
3 жыл бұрын
Hey mate, nothing wrong with the redarc mind you! Yep just got back from a trip now (catching up on replying to comments :) ) and was towing the camper trailer this time and is soooo much better being right there to be able to adjust on the fly.
@tylerjones3875
3 жыл бұрын
Smart way to route the wiring to the back. Wouldn’t have thought of that 👍
@colintaylor9231
2 жыл бұрын
Fantastic Video Adam I have always been little afraid of this type of installation (not very good with electrics) but your demo was very helpful and has encouraged me to have a go Thank you very much Kind Regards Col
@geoffreygibson8680
2 жыл бұрын
What a legend I'll give a few of yr installs a go when my d max arrives later in year even though I'll butcher it
@stuartgilbert3969
Жыл бұрын
Spot on. Thanks heaps for a really easy to understand, informative video.
@PeterHowell-q3o
Жыл бұрын
adam good video /just a question when towing with a 2018 d-max auto with 23 ft caravan what is the best way is to let the auto do its own thing or keep it out 4/5/6 manually??
@VideoShowMeHow
Жыл бұрын
yeah I usually let it do it's thing on the flats, when up or down hills I usually flicked it into manual mode
@jeffreyhearn9652
3 жыл бұрын
Pick my xTerrain up tomorrow. Can’t wait
@VideoShowMeHow
3 жыл бұрын
Let the fun begin!
@tylerjones3875
3 жыл бұрын
Can you do an install vid of Redtek Auto Mirror Fold? Thanks
@VideoShowMeHow
3 жыл бұрын
Funny you should ask, auto fold mirror module coming up in this Friday's release!
@tylerjones3875
3 жыл бұрын
@@VideoShowMeHow Ah Sweet! Ha. That’s pretty flukey! Can’t wait to watch it! Thanks for making a vid of it!
@Warnut
3 жыл бұрын
you need to contact max liner for the updated rear floor mats if you havent already :)
@VideoShowMeHow
3 жыл бұрын
Cheers yep, received my updated rear ones 👍
@Warnut
3 жыл бұрын
@@VideoShowMeHow ah sweet same here they should automatically send them out but alwell. another great video btw keep the good work up :)
@VideoShowMeHow
3 жыл бұрын
@@Warnut cheers mate 🤘
@mattshields1813
8 ай бұрын
Why not just remove the bit with blue wire coming out and connect the harness directly where the 7 plug trailer wires connect to the car using the smart connection?
@luigifiorillo7680
2 ай бұрын
Hi Adam, Do you have a video where the back part of the floor console is accessed. I remember seeing a video where it shows a lot of space under the lower side of the storage compartment. Wanting to access this area to install cigarette plug. Can’t find video on disassembly.
@VideoShowMeHow
2 ай бұрын
The centre console? In the UHF install vid. Can access via the cup holders
@luigifiorillo7680
2 ай бұрын
I’m looking to access further back beyond the cupholders under the actual storage compartment? I remember seeing a video somewhere but am unable to find it. I thought it was your content.
@kerronsooklal4500
2 жыл бұрын
Are those genuine door visors?
@VideoShowMeHow
2 жыл бұрын
Aftermarket, link in vid descriptions :)
@MarcusKabas
Жыл бұрын
Clicked on your link , says controller + wiring kit , bought it and just arrived , no wiring kit only the controller , have to buy the wiring kit separate , another 120,-
@leesanders332
3 жыл бұрын
Hi, Can you tell me where you got the rail cap for the tailgate? Been searching for one but unable to find one for my X-Terrain as yet. Like me it looks like you have the roller cover fitted as well. It's good to know there's one out there which is compatible . Thanks in advance, Lee
@VideoShowMeHow
3 жыл бұрын
Sure thing, have updated the description with a link for you
@leesanders332
3 жыл бұрын
Also, do you have a cover on the lock/handle on the rear tailgate? If so can you share the product link please?
@VideoShowMeHow
3 жыл бұрын
@@leesanders332 no I don't, handle all factory
@leesanders332
3 жыл бұрын
@@VideoShowMeHow interesting how the handle on the cobalt version is black (paint or plastic?), but on my obsidian grey its colour coded.
@VideoShowMeHow
3 жыл бұрын
@@leesanders332 Ah really? Didn't realise there you go. Mines same colour as the flares
@unrealshots
2 жыл бұрын
Nice video, I've observation - the vents at the back are supposed to be one way for air flow, by running a cable through, you can get dust and water ingress inadvertently... (Seen it on customers cars not work by us)
@VideoShowMeHow
2 жыл бұрын
So far so good, but haven't been on anything crazy dusty. Will be interesting to keep and eye on over time 👍
@kapilapatikiriachchige7658
Жыл бұрын
Nice instruction and video// :)
@PeterHowell-q3o
Жыл бұрын
thanks adam
@croydonq135
2 жыл бұрын
Great video thanks
@conanlovelock6941
2 жыл бұрын
Hi Adam, do you know the name of the plug they use for the trailer break/brake line.. I have the 12 pin loom and want to replace the blanking plug with functional to use with the redarc controller.. Thanks
@VideoShowMeHow
2 жыл бұрын
Noi don't sorry mate. Maybe someone else here or on the forum might?
@conanlovelock6941
2 жыл бұрын
@@VideoShowMeHow thanks for the reply, I'll pop down to autobarn and see if they have one.. Otherwise I'll just cut them off and join manually
@tomskimcdouglegaming806
7 ай бұрын
Can I install this into an existing harness? Thanks.
@VideoShowMeHow
7 ай бұрын
Yeah you could
@tomskimcdouglegaming806
7 ай бұрын
@@VideoShowMeHowChur
@lopes8566
2 жыл бұрын
When I connected mine to the battery and tried to push on the button I didn’t get the red light come on like yours? Any ideas?
@Tyson.struber28
Жыл бұрын
Hi mate, mine has done the same thing. Are you able to share how you fixed it. I have checked the red (signal) wire and it has 12v. System has 12v and a good earth. I have checked the blue wire at 12 pin plug and no power. Plugged into trailer has a constant green light and no flashing light. I'm stumped. Any help appreciated.
@justincapes1516
2 ай бұрын
@@Tyson.struber28 hey any luck on a fix i think i have the same problem
@gregpaterno1446
3 жыл бұрын
Top job how can you not subscribe on your videos very neat fit keep them coming 💪🏼👍🏽🇦🇺👌🏼🍻🤙🏻☝🏼
@Sisu2280
2 жыл бұрын
I've got a 2022 Dmax - why in the world aren't these standard from factory? Not even the wiring harness for the towbar is standard. The ute can tow 3500 - an integrated Isuzu system should be standard.
@VideoShowMeHow
2 жыл бұрын
Yeah would be good hey, at least the output plug is there at the rear to plug into I guess
@heywandy
3 жыл бұрын
Hi Adam, where did you get that piece of black trim that protects the top rail of your tail gate?
Пікірлер: 63