Great Install, the only issue being that you put screws in the bottom of the sleeve. Even though the unit is sloped to drain outside in the event of a backup holes in the bottom of the sleeve inside the wall could lead to water damage over time
@mq9167
4 жыл бұрын
Tip: use a stud finder that also can locate wires so you know where any hot wires are.
@josron6088
4 жыл бұрын
Thanks for putting this up, finally a video showing me how to properly do this.
@joev4410
2 жыл бұрын
Your video shows how to make the existing hole through the wall wider to accommodate a larger sleeve. I need to go in the opposite direction since my new a/c sleeve is a little more than 1 inch shorter (in height) than the one currently installed. How would you recommend "patching" the gap from both the inside and outside of the house?? Although the a/c is installed under the eave of the roof, I want to make sure no driving rain/snow finds its way into any gaps. Thanks in advance for your help.
@telumears
Жыл бұрын
Did you ever get any answer to your question of determine how to make those adjustments? I have the same issue as the newer models are a bit more compact than my old Kenmore from the 80's! Thanks.
@joev4410
Жыл бұрын
@@telumears I did not, but came up with a way on my own. I bought a piece of pressure treated wood (in my case approximately 1.5" thick x 6" deep x 25.5" wide) from Home Depot and screwed it securely into the wall studs running along the bottom of the opening in the wall that the a/c sleeve fits into. That filled in the original gap between the bottom of the a/c sleeve and the wall perfectly. I then caulked all around the opening (including the new piece of wood) very well from both the inside and outside of the wall to make sure no rain/snow/insects would be able to get in. A picture would have been worth a 1,000 words, but I'm not able to attach 1 here. If you also need to fill in a gap width wise, you could take the same approach as I did height wise that I just described. Hope it works out for you.
@shopinthebasement4262
2 жыл бұрын
Don’t hit like often, but the RBZ hat was a must for me 😂😂
@safdarally5690
9 ай бұрын
Great video How much bigger did you make your opening?
@WanderlustWonderscape
Жыл бұрын
2:38 - I once had a debrise come into my apartment and it took months to get rid of.
@gvet47
2 жыл бұрын
Tapering the drywall piece and the wall above sure make it easier to tape and drywall with minimum show.
@aspondy5524
2 жыл бұрын
Great video! I have a new ac wall unit I bought last year. What can I use in the sleeve to reduce loud vibration from the condenser? Thanks!
@armandocontreras8114
Жыл бұрын
Thanks for your time
@WaterN2WineCreations
11 ай бұрын
I don’t understand putting something in a hole through an exterior wall with absolutely no flashing. When water gets to the wood what will happen? Do it all over?
@fernandosanfranciscoca9278
Жыл бұрын
I would have just cut the drywall wide enough all around and do your framing then put drywall back and mud. Much easier.
@Bocheap
3 жыл бұрын
Great install, does that ac unit cool good installing that low.
@gvet47
2 жыл бұрын
Remember he was using an existing location and outlet. Always a problem in furniture location as well. Grills can be pointed upward to help but a ceiling fan is a good idea as well.
Пікірлер: 16