Today we start by getting the ball joints tore apart and ready for plating and paint. We then move up to the headlight and wiring harness to get that stuff cleaned up and painted and then we finish it off by getting the front brake cables put on!
If you like what we're doing here at Toy Shop and would like to support us then be sure to check us out on Patreon! www.patreon.co...
Using these links will help me out!
Blade Fuse Holder - a.co/d/7SSHtdp
Toolbox Widgets
1/4" drive Socket Widget - a.co/d/29Ux2rs
3/8" drive Socket Widget - a.co/d/5cCi3mT
1/2" drive Socket Widget - a.co/d/8EsPl9s
Screwdriver Widget - a.co/d/5F7EB5Y
Wrench Widget - a.co/d/0qyVzIM
Wide Motorcycle Scissor Jack - a.co/d/fQLQypt
Narrow Motorcycle Scissor Jack - a.co/d/cGDv73u
Umbilical tank setup;
Moton Pro Aux Tank - a.co/d/2hMd2xe
IV Stand - a.co/d/hHiSSGU
Metric #2 Phillips - a.co/d/1qhV0me
Slide Hammer - a.co/d/e8bu3yW
Camera I use to film - a.co/d/9d39Jjm
Mic I use - a.co/d/0V4vNZ7
Visit us at www.toyshop966... to see what we're up to and to check out everything Amsoil has to offer!
Негізгі бет Headlight Is On and Tie Rod Ends are Zinc Plated! | Moto 4 Restoration Part 3
No video
Пікірлер: 1