This is a game changer... technology in action! 🌞📡🔝👏🎉
@jeffblack7180
4 ай бұрын
It is Jimmy! Off grid communication! Thanks.
@ShotokuTech
4 ай бұрын
Yes Jimmy!
@JudyFayLondon
3 ай бұрын
Such a fantastic share!
@ShotokuTech
3 ай бұрын
Many thanks, Judy!
@JudyPlus
3 ай бұрын
This is marvelous!
@ShotokuTech
3 ай бұрын
There is so much to learn. There is so much to do. This is a good place to be Judy. Thank you.
@leonardosilveira06
3 ай бұрын
Hello friend, I would like to understand if with meshtastic it is possible to communicate between two heltec lora v3 where one sends a command to activate a relay in the other heltec lora module?
@MULAMIGZ
4 ай бұрын
Nice 🔥
@ShotokuTech
4 ай бұрын
Thanks. Best wishes.
@Jerf-ou6jx
4 ай бұрын
Thanks sir. Can't wait for the next video! Will the serial outputs/packet data be monitored as sync through CLI? Sir, I'd like to ask you if applying this CLI so we can make all the rangetest transmission of rx_packets including rx_rssi, where it cannot be recorded in the exported csv. file, while it is shown in Debug Panel (only valid for android mobile app) that not only can be displayed but to be exported into supported file like csv. or even log.?
@ShotokuTech
4 ай бұрын
Just so you know, I have never done this before. I'll have to figure it out as I go along. Thanks!
@gtorres1719
4 ай бұрын
Hey, Do you know if a Micro JST 1.25mm connector battery will directly fit the Heltec? If not what connector does it use?
@ShotokuTech
4 ай бұрын
Hello. These are the batteries I used and the have that JST 1.25mm connector. So your are good. amzn.to/4bfTZHW
@abdullaqasem4861
4 ай бұрын
I have a Heltec ESP32 WirelessStickV3 module, and I want to measure time with precision in the range of 100x nanoseconds. I'm aware that the module may not have the capability to count time intervals this small, even with a clock frequency of 260 MHz and an 80 MHz APB. I have tried to use a timer interrupt to count the number of ticks with a prescaler of 1 (meaning 12.5 ns per tick), but encountered continuous restarts of the ESP32 and application crashes. This could be due to ISR overhead or the excessive number of interrupt updates, which may not be supported by the module. I also tried using IRAM and other methods to reduce processing time, but without success. I'm open to any suggestions or advice you might have on how to achieve precise time measurements in this range. Thanks for your tutorials.
@ShotokuTech
4 ай бұрын
If I can google the code I'll let you know. I don't have the Stick to test with. Yeah I can't say anything comes to mind for this. My mind keeps wandering to an RTC. Best wishes.
@abdullaqasem4861
4 ай бұрын
@@ShotokuTech Thank you for the reply. Do you know if there is a good way to measure the time of flight for LoRA signal with good accuracy?
@JudyFayLondon
4 ай бұрын
I wonder why I don't see ads at the beginning of this video🙃
Пікірлер: 19