Valid for Volkswagen Transporter, Caravelle & Multivan from year 2016. T5.2 install is also possible but you need to upgrade your BCM.
IMPORTANT: your mirror already need to have automatic dim as well as rain and light sensor installed and wired. There will be another video on how to install this if you don't have it.
Parts required:
T6 mirrors (9B9 at the end is the dark grey color code, it can be any other):
7E0857511F 9B9 (with frame/rim) or
7E0857511G 9B9 (rimless) or
7E0857511E 9B9 (rimless)
Cap for the camera: 3G0858548A 9B9
MQB mirrors can be used too after re-flashing using ODIS or VCP.
Best one, that was used in this video:
3G0857511AE 9B9 - rimless mirror
5G0857593B 9B9 - cover cap for the wires (needs trimming a bit)
5G0858548C 9B9 - cover cap for camera
Wiring - 2 meters of can-bus wire, could be any other wire of at least 0.25mm^2
Pins:
979009E (or 979009, or N90764701) - 2pcs for the Body Control Module.
979034E (or 979034, or 12527510672) - 2pcs for the mirror connector. For this pin the following are the substitutes: Tyco 7-1452653-1 or 1452668-1, BMW 12527510672, BMW 61138369696, Mercedes A0215450126, 1718653, DJ623W.
Pins can be sourced cheaply on ebay or Aliexpress.
Detailed information about the HBA installation:
(link in the comments)
More info on MQB mirror reflashing:
(link in the comments)
If you need any of the parts, just reach out to me. I occasionally have surplus in stock.
Негізгі бет High Beam Assist install on VW T6 (HBA/FLA retrofit)
Пікірлер: 13