Hi Darren, Some very helpful and original tips. It’s been a while since I fired up the 3D printer so I better get cracking so I can end up with a few spools for my extension cords. Thank you for sharing. Cheers 👍😎🇦🇺
@DarrensWorkshop
2 жыл бұрын
Thanks John
@PTEC3D
2 жыл бұрын
Cool tip with doubling the extension cord over then rolling it on the reel.
@DarrensWorkshop
2 жыл бұрын
Thank you, Have a great day.
@bloke875
2 жыл бұрын
Good to see you’re back, I thought the hot weather had kept you out off the workshop!
@DarrensWorkshop
2 жыл бұрын
Hi Peter, you are right, the hot weather and general life stuff. It’s good to be back.
@Tensquaremetreworkshop
2 жыл бұрын
I have been looking for a use for used 3D printer filament reels. Sadly, my extension cord (never felt the need for more than one) is already on a reel with a winder to wind in in. But your idea for using it to store rope could be a winner...
@DarrensWorkshop
2 жыл бұрын
Chees Mike
@sumosprojects
2 жыл бұрын
Hey Darren, you do realise that there are a lot of Aussie KZitem channels out there doing woodworking yeah ? Many of them give fantastic tips & I encourage you to join in with our family of DownUnder makers. See ya mate
@DarrensWorkshop
2 жыл бұрын
Hi Sumo. Yes there are some great Aussie woodworking channels. So how do I join the family?
@sumosprojects
2 жыл бұрын
@@DarrensWorkshop Seek em out & say G’day
@sumosprojects
2 жыл бұрын
@@DarrensWorkshop Search for Aussie KZitem channels & say G’day 🤠🇦🇺🍻
Пікірлер: 12