One improvement is to use a sheet of plastic taped to the hull. When you have painted the Gel coat onto the edge you can then, fold the plastic over the edge with the gel coat underneath and tape it tight to the hull. The Gel coat will not stick to the plastic when hardened and the edge will be the same rounded profile of the rest of the boat, saves a lot of sanding as well. Plastic sheets come from Office supply place - used for older overhead projectors.
@martinetkin2548
2 жыл бұрын
Another trick is to use mylar (polyester film) applied over the gel-coat to create an almost perfect surface.
@Andrew-qv2qu
4 жыл бұрын
How long did you leave from applying to sanding? Ie drying time..
@gerdde4241
6 жыл бұрын
I dont' understand the last step. What was the material for polishing?
@davetreagust9273
6 жыл бұрын
Hi! We use a finishing compound called Farecla G3, available on our website here -> www.roostersailing.com/pd/Farcela-G3-Finishing-Liquid-Paste---400g_102518.htm
@nickmiller1226
3 жыл бұрын
If there are scratches?
@Ryansi27
10 жыл бұрын
What was used in the last step ? Can't hear
@Ryansi27
10 жыл бұрын
Thanks
@lorenzo6553
3 жыл бұрын
fur Eckler if u still care
@walkertongdee
6 жыл бұрын
Whats a Bugget?
@technicstim
6 жыл бұрын
should remove the tape about 20mins after you finish it comes away lovely then
Пікірлер: 11