Hatachi tv wont turn on , it has a orange and green standby light wont pass this.
check capacitors and change out the blown capacitors to fix this problem.
easy tv fix , fast tv repair
If this has helped ou fix your tv - why dont you buy me a beer!
donate link -www.paypal.com...
So in this video today we are going to identify some bad caps and replace them on this VESTEL Power Supply. S. First we can unplug the TV , on this power supply we have identified some bad caps, so here is a here are some good caps here, they have nice flat tops, no leaking nothing is wrong with them and right next to them we have these caps right here and you can see that there tops are bulged up and they are also leaking out this kind of brown ooze which means they are defective. Every once in awhile you will get caps that are defective but do not show signs like that but almost every time you are going to see this puffiness and you are going to see if it is really bad, fluid leaking out of them. So bad caps can manifest in a number of ways, you might find the TV will not power up or more commonly it is going to take multiple attempts for the TV to power up. Once it is on, it is going to work fine, but again when you turn it off, you will have to try multiple Times to turn it back on. Over time this tends to get worse as the cap start to degrade even more. And it will take more and more attempts to get the TV to turn on. Once in awhile if the cap tends to be in a different place you can get noise in the picture but usually it is the issue with the TV starting up that is the problem. So we have gone ahead and flipped the board over if you are having trouble trying to find the cap you are trying to replace sometimes if you just put your finger on the other side and just pinch it kind of shows you the location otherwise it can be kind of hard to locate them on the back. Now we know where our caps are, we are going to go ahead and use our Hakko 808 desolder gun and just heat up the joints let it melt suck it up and the same on the other side and as you can see the cap actually dropped right out of the board so you know it is removed. And we can go ahead and do the second one, same thing heat it up, vacuum it out and the other side. And there you go they both dropped out, now the joints are clean and now we can go ahead put in our replacement caps. So here we have the original cap that we removed from the board, and this is a 16 volt 2700 microfer and 105 degree cap and it is really important that when we get a replacement cap that we choose the same values.
TV MODEL IS 42LDF30UA
Негізгі бет Hitachi tv stuck on standby - power supply easy fix - 42LDF30UA MAKE MONEY TUTORIAL
Пікірлер: 22