Shake it Up and Down like most of the trailer motion and rattle comes from. Not the side to side.
@williamko4751
2 жыл бұрын
You can also buy a hitch clamp off Amazon for $9. No hassle.
@rossevans1774
Жыл бұрын
Don't use a bolt for a hitch pin!
@buddyboy4x44
3 жыл бұрын
I would not trust a lock washer for safety reasons. I suggest you also drill out the bolts and use a pin in the same way that the tow bar is normally secured.
@ToyotaKTM
4 жыл бұрын
That WILL loosen up. The lock washers aren't going to keep it from loosening. You need a locking nut at the least. I would use a Nylock nut and red locktite threadlocker. I hope you have good safety chains and they're installed so that they cross, under the hitch.
@TheSkyPod
5 жыл бұрын
couldnt you just glue a couple washers to both sides of the shaft instead of drilling , and use a bolt to tighten then ?
@geraldwilliams3898
3 жыл бұрын
Ty brother
@marioh.4361
4 жыл бұрын
simple and quick
@brucebannerman6848
2 жыл бұрын
I take the hitch of when not in use, simple,legal and no rattle,
Пікірлер: 9