I purchased my new 2012 PA back in December. I almost got the 2013 because I loved the new hatch and flat floor. I didn't like the new seat however. So after much thought I figured out a way to make the new 2013 hatch fit in my 2012. This required a lot of patience and a substancial amount of plastic welding. Along with the hatch project is everything else I've done to it thus far. The complete hatch project can be found at Hobie forums under the Pro Angler section. I know this is a long video but there was alot to cover. Sorry about the editing. I'm not very good at it. Thanks and enjoy!
Carl
Негізгі бет Hobie Pro Angler 14 Custom Hybrid
No video
Пікірлер: 107