My turbo Identical.. except. The gear tooth has lines on the turbo to lign up with. One is full vgt other is none. This is in the cummins manual and used during calibration. My vane cartridge has two snap rings. Both are in the hot side snail and impossible to remove. Looking down into the hot snail, first ring is inside to capture center cartridge. In addition to the outer clamp. Second one locks the vane plate into place. These are cummins holset turbos. So not sure why yours is missing these.
@DIYKAI
3 ай бұрын
What year and model truck? What’s the turbo number? Cummins made 2 different turbos to my knowledge
@DIYKAI
3 ай бұрын
I have a special calibration tool so it didn’t matter for us
@turboflush
3 ай бұрын
@DIYKAI this is a 2018. However the earlier ?2016? Has dame build just different hot snail. Still has the c clips. Only way I can think to get the vane disc out is to destroy it.
@DIYKAI
3 ай бұрын
@@turboflush yes we had to collapse it and deform it to remove. 2016 was the later style turbos....2013 they started to change them
@HanktheTank349
3 күн бұрын
Quick question for you… have you ever seen the coolant side of the turbo leak?
@DIYKAI
3 күн бұрын
@@HanktheTank349 from the line connections yes
@HanktheTank349
2 күн бұрын
@@DIYKAI do you want honk it’s possible to be leaking into the turbo? I’m getting excessive pressure build up in my radiator and it’s pushing coolant into the reservoir. I’ve done a pressure test and combustion gas test already.
@DIYKAI
2 күн бұрын
@@HanktheTank349 if your building pressure it would not be from the turbo....pressure test will only show you a leak.....you might have some head walk or a head gasket starting to go out....have you checked the torque on your head bolts I have seen them loose before
@HanktheTank349
Күн бұрын
@@DIYKAI I haven’t checked the torque on them yet. I’ll look into that. I have to rebuild the turbo anyways, the bearing is making a high pitch noise… which is why I found your video. Thanks for your help
@DIYKAI
Күн бұрын
@@HanktheTank349 your welcome and good luck this one is still running strong just ran it up the east coast
@kenwoodguillory7340
6 ай бұрын
What's the name of the tool?
@DIYKAI
6 ай бұрын
the one that drives the seal is this one: amzn.to/3ttSDc8
Пікірлер: 28