If we forget to on the radios or edge corner curve switches. Any way to make it reinsert
@dala7862
2 жыл бұрын
Do you mean re run a part after milling one side? You can do it if the opposite side hasn't been milled. Re-run the original side again correctly and then run the opposite side with a 0mm offset. Just remember to set the offset back to your original setting after you are done using it or your next part will be wrong.
@joelzsilva9740
2 жыл бұрын
hello. nice video can you help me ? I need know what are the steps for the starter machine homag optimat KAL 310/3/A3/S2 . thanks .. best regards !!
@ismailaolawunmi1191
2 жыл бұрын
How can I join the class?
@StilesMachinery
2 жыл бұрын
Hello, all Stiles University classes can be found at: www.stilesmachinery.com/education-training/courses
@stalevuycryck9068
Жыл бұрын
Hello! Greetings from Ukraine. Tell me, please, what kind of unit is the last one? Thanks for the video!
Пікірлер: 7