Hi today we will be smashing out a small job in a cheap piece of pine using 4 operations #1 surfacing #2 2d Adaptive #3 2d Contour and the final one is to run a chamfer I was advised to add an M1 command to the G Code just after it gets to the combined 12.5 mm clearance height and the 12.5 mm retract height which totals 25mm and so now the spindle goes down to 25mm and stops and I can check that height with a 123 block if it's the correct distance I hit cycle start and away it goes No Crash Ok enjoy cheers Bill
- Күн бұрын
Home Built CNC 4 Operations with 3 tools in Pine with crash problem fixed
- Рет қаралды 1,637
Пікірлер: 31