Never trust the fuel from the Previous owner. Thx for the tip/reminder about these carbs disassembly and the needles and emulsion tube. Removal b4 the needle float assembly, it's been awhile for me too on this design carb. I acquired a 4400 homie recently and haven't gotten to it yet.
@drunkingsailor2359
Ай бұрын
The rolls of velcro works great in this application
@drunkingsailor2359
Ай бұрын
You were supposedly going to empty the old fuel.
@billk9628
Ай бұрын
Those carburators have issues with vibration. I had one with the float seemed to be stuck open, and I reset it multiple times and no luck. 11.5 on a roper 1132 snow blower. Would run great, til you caught something frozen in the driveway. Then it stumbled all over the place til you stopped moving and then it would return to normal. The carb kits didn't fix the issue either. The float just doesn't hold the needle shut under movement, and it would just flood out, til you stopped moving, and then it ran beautiful,,, til the next time.
@philliphall5198
Ай бұрын
Put a manual fuel cut off valve is what I did 😊
@philliphall5198
Ай бұрын
I have the same generator in tool box of my 1980 Chevy service truck and have not looked at it since I quit using it but did drain tank and carb Was nothing wrong with truck or generator just didn’t need it so I parked it on cement blocks 😊
@philliphall5198
Ай бұрын
Good time to check valve lash also and dump the old gas please Got to go back into shop break is over 😢
@philliphall5198
Ай бұрын
These are great old gens but put a manual fuel cut off valve and drain tank if not using regular and run carb dry , put hour and tack meter on it for best results
@drunkingsailor2359
Ай бұрын
It's not up to speed for 60hz output
@philliphall5198
Ай бұрын
Do a leak down test first and then you will know for sure 😢
@philliphall5198
Ай бұрын
That’s a bad blown out gasket, head bolts must have been really loose 😢
Пікірлер: 11