very very nice i want to do this. do you have a parts list?
@swan7654
2 жыл бұрын
I do not but basically you need a 36 tooth sprocket on the jackshaft and a 11 tooth sprocket on the motor shaft...depending on what speed u want you can either adjust the sprocket sizes or adjust the voltage going to the motor ...lower volts = lower rpm. I used #35 chain, like I said in the video you don't need All the fancy stuff...a simple switch for open /Close works the same.
@bodeine454
Жыл бұрын
Have you had any issues with the door binding because of the motor and sprocket lifting on one side only?
@swan7654
Жыл бұрын
@@bodeine454orry for the late reply, no I have had no issues with binding The only issue I had was in the early stages of install. I didn't have the limit set yet nor fuses installed. It was just temporary and one of my family members ran the door and it kept driving down into the floor but I managed to fix it myself. Therefore, if you ever do this, be sure to install a fuse to trip when the motor is working hard due to a limit failing or something jamming door
@bodeine454
Жыл бұрын
@@swan7654 That's a good idea, thanks for the info.
@1Silverlining
Жыл бұрын
Coming from a former installer of access control, well done sir, well done.
@swan7654
Жыл бұрын
Thank you for the kind reply, I work as an industrial electrician therefore have some good knowledge of controls!! Love it
@michaelopry3456
10 ай бұрын
very nice! pretty ingenious. thanks for sharing, this gives me another project that I wont have time to complete.
@swan7654
10 ай бұрын
Hey thanks!, its always fun making things and even better when they serve a purpose!
@mrmista101
7 ай бұрын
How many amps is your power supply
@swan7654
7 ай бұрын
I believe it's a 5 amp supply fused at 3 amps haven't had it blow a fuse
Пікірлер: 11