The key to this whole thing are the Pillow Block Bearings (3/4"). Picked up two of them on Amazon and mounted them to a 1x2 with a 3/4" hole drilled through the middle. This slides onto the 3/4" rod mounted to the top of the 2x4 with some electrical conduit brackets. All together the hardware cost me about $30 in July of 2023. I already had the steel base and wood.
Still experimenting with the placement and amount of weight on the bottom to find the optimal swing speed and presentation.
Parts:
(2) Pillow Block Bearings a.co/d/2zrUgU2
(2) 5/16" - 2" threaded bolts
(2) 5/16" washers
(2) 5/16" hex nuts
(2) Locking washers if desired
(1) 3/4" rod
(2) 1" Electrical Conduit Brackets
Base Stand
2x4
1x2
Негізгі бет Homemade DIY USPSA Swinger Target
No video
Пікірлер: 7