Thanks for sharing. I followed it and repaired my civic’s clock display. It was mere issue of dry soldering. Resoldering pads resolved the issue.
@mopro5663
4 жыл бұрын
If you dont live in UK . See the video in a mirror and it would work for you too
@andresilvasophisma
Ай бұрын
The left part of the clock is very hard to take out by trying to pull it with your hands. One easy way to do it is fitting a zip tie near the clip, try doing it from the top and using the wall of the console to guide it down, once you have both ends of the zip tie just pull them both towards you and the clock will come off.
@groggy8369
3 жыл бұрын
Thank you very much. This was very helpful.
@bekire2215
2 жыл бұрын
Thanx, that helps very much
@juhanzabiullahyeo1341
Жыл бұрын
😊thank you for informing ❤😊
@mixlimantz
3 жыл бұрын
Thank you for the video. I soldered again the pins. 7-segment displays are ok now. But, the illumination is too faded. Any advice??
@johngr9963
2 жыл бұрын
Thanks fella,. 👍👍👍👍😁
@krzysztofskolas5210
9 ай бұрын
Thank you
@YouSt0leMyHe4rt
5 ай бұрын
I wonder if I can change it for a type R digital clock
@gessto1
3 жыл бұрын
You mentioned that you couldn't see the digits properly, how did you short that out? Im in uk too actually 👍
@Belky83
2 жыл бұрын
You’ll see some pins on the motherboard, they need re soldering
@ThePauwa
3 жыл бұрын
hello, can the car be driven with the screen removed?
@Braddas1977
4 жыл бұрын
hi. i need to remove the speedometer on my civic. do you have any guides for how to go about this?
@D11111
4 жыл бұрын
The digital speed readout? You lift the cover upwards and then pull it forwards.
@gessto1
3 жыл бұрын
I have the same clock, how did you repair yours? Mine doesn't show the digits well, is that what yours did?
@mattwasley2486
10 ай бұрын
comment is two years old but did you sort it?
@Misbah007
4 жыл бұрын
I m struggling to take out one side of digital clock. The passenger side corner would not come out. I m using all my strength. Only way is to brake the thing Just don't know what to do .please help
@ianoliver4290
Жыл бұрын
For a RHD car it's easier to release the left end first. If you pull out the right end first it jams the left hand end. Basically it has to come out parallel with the face of the facia the way the clips are angled.
@gessto1
3 жыл бұрын
If you had yours repaired maybe i wouldn't have to get a new one myself
Пікірлер: 21