You've Sold It To Me. Ordering Now. New Rider from London
@CodgerBiker
Ай бұрын
Thanks for watching. As I always say, don't copy me. I'm just trying to improve my bike to suit me. Good luck! 👍
@marcus577
Ай бұрын
@@CodgerBiker Good Morning I like to sit more upright. Just a week with a New DCT. What is the Torque setting for the handlebars. Could have saved the postage by buying at SportBike Shop oh well too late.
@CodgerBiker
Ай бұрын
I used 28nm (which I believe is Africa Twin spec) but you should check for yourself. Also make absolutely certain cables, especially brake lines, are not stretched. Bike tolerances vary. Mine is a manual.
@malcolmtwigg7841
2 ай бұрын
hi thanks for posting this vid. its not the clutch cable you need to worry about but the ruber brake line that i found streched and if that goes you will loose all your brake fuid!!
@CodgerBiker
2 ай бұрын
Yes I checked it after your previous comment. All seems ok at 20mm. But, of course, there's no guarantees. 👍
@marcus577
23 күн бұрын
I received the bar risers last week. I gave my dealership them with the R&G radiator cover. Unfortunately they said there’s not much cable but before I stepped in he said I’ve fitted the radiator cover for free. You a anywhere near Essex London???Free Fosters 36 cans.
@CodgerBiker
23 күн бұрын
Sorry, NW. But there is likely some variation in setups. If dealer not happy then I'd leave them. Not worth the risk of losing front brake, worst case scenario.
@DeLorenzo8588
Ай бұрын
what torque did you use?
@CodgerBiker
Ай бұрын
I went with 28nm. Which I think is Africa Twin setting. But don’t quote me on this. 👍
@DeLorenzo8588
Ай бұрын
@@CodgerBiker дякую! (Thanks)
@CampbellZeroOne
2 ай бұрын
So it is true then. Honda riders aren't manly enough to drink coffee 😉
@CodgerBiker
2 ай бұрын
Tea and Shandy only! 😉👍😂
@CampbellZeroOne
2 ай бұрын
@@CodgerBiker I bet you and DrJ spent half of your morning arguing whether you should hold your cup in the left hand and biscuit in the right, or vice versa 🤦🏻♂️😂
@CodgerBiker
2 ай бұрын
I swear he just does it on purpose! 😉
@CampbellZeroOne
2 ай бұрын
@@CodgerBiker 😂😂
@TimmyTookaLook
2 ай бұрын
Dots to top, the clamps should be finger tight and NO gap at the front where dots are. Torque front first then rear. There's a dap of paint on a center punch mark on the bars to the left of the top yoke mounting this should be next to corner of mounting for correctly aligning middle and rotation of bars. The clutch cable will rub by ignition after a couple of thousand miles but doesn't seem to bend it. I also found that bar end fitted Bark Busters fitted perfect with this set up
Пікірлер: 18