Just want to say thanks for being so thorough with this video, im 15 and just bought a project xr80, and this video REALLY helped me out for my first engine rebuild. Thanks man!
@lowcountryjeeper
4 ай бұрын
No problem, glad to have been able to help. Thanks for watching.
@kylebanker5293
Жыл бұрын
Really appreciate your effort to not miss any important details thank you awesome video.
@lowcountryjeeper
8 ай бұрын
Thanks, I know some of the videos can be long winded however details are key.
@colingladfelter9520
Жыл бұрын
Thank you for the great video!!! Im in the same situation and struggling until i found this!
@lowcountryjeeper
8 ай бұрын
Thanks so much!
@TN_HondaDad
Жыл бұрын
NO NO NO NO NO NO!!! Arrow faces toward the exhaust!!!! Your piston is 180 degrees backwards! Another indication will be the intake indentation on the piston will be larger than the exhaust indentation. (Intake valve bigger) Everyone freaks out about the chain dropping down. Just use a telescopic magnet to fish it up instead of trying to hold it up and getting in the way. Just did rebuild and learned this so passing it on. Especially if you are removing the cylinder, as you can almost just reach it with your fingers.
@McDizzleDrizzle
Жыл бұрын
Did you home the cylinder in your rebuild? I’m trying to figure out if I have to, it looks good to me
@arpalmer09
Жыл бұрын
What tebud kit did you use
@TheChaz81
10 ай бұрын
@@McDizzleDrizzleyea you should so the new rings have good cross hatching to seat.
@lowcountryjeeper
Ай бұрын
so In the video there is no arrow on the piston. There is an “N” stamped into the top of the piston to indicate that is the intake side of the piston
@seank24
Жыл бұрын
Thank you so much!
@lowcountryjeeper
8 ай бұрын
You’re welcome, thanks!
@troyholland3436
4 ай бұрын
I have a Hondaxr100r 1987 motor runs so good it’s crazy how good it runs for the age I’m questioning if it’s been rebuilt recently or if it just haven’t been ridden much what yoy think is more likely? It’s just crazy how smooth it sounds
@lowcountryjeeper
4 ай бұрын
Possibly just has low hours or could have been rebuilt. Hondas are hard to beat. Enjoy it and thank for watching.
@owensbama1923
7 ай бұрын
Your piston is 180 out. You said it backward. Arrow points to the exhaust. Larger cutout is for intake valve.
@lowcountryjeeper
4 ай бұрын
Thanks for watching
@Everatti
Ай бұрын
Just realizing this now. And I just torqued everything to spec. Looks like I have to take it all back apart down to the rod..
@lowcountryjeeper
Ай бұрын
@Everatti so In the video there is no arrow on the piston. There is an “N” stamped into the top of the piston to indicate that is the intake side of the piston.
@lowcountryjeeper
Ай бұрын
so In the video there is no arrow on the piston. There is an “N” stamped into the top of the piston to indicate that is the intake side of the piston
@Everatti
Ай бұрын
@@lowcountryjeeper Okay my mistake. Going to see if I can check through the spark plug hole so I don’t have to pull the whole thing apart again today haha. Thanks for the quick reply, video was super helpful
Пікірлер: 27