Hello from Finland. Nice presentation. I have hakki 400 prosessor and a ferrari radio controlled crane that is coming in front of a komatsu radlader as project.
@DanielKornfeld
6 ай бұрын
@paavo2525 Greetings to Finland! Thanks! Cool, that's very close to ours! Does the device also save you a lot of work?
@paavo2525
6 ай бұрын
@@DanielKornfeld Thanks, now I have prosessor trailed behind a county tractor. Jump in an out, move it a bit then nearly hita a remaining tree, round and move again, round and so on. Count go almoust everywere, thats why I will try it in front of a wheelloader, whit a radio controlled crane. My reply yesterday dissepeared, whit some picture links,
@DanielKornfeld
6 ай бұрын
@@paavo2525 With pleasure! You can set up the crane on the wheel carried processor. Then you don't have to get out every time. Mounting the processor on the wheel loader can also work. Unfortunately, I see no links to the pictures.
@paavo2525
6 ай бұрын
www.maskinisten dot net /userpix/22199_1EZ61P2YO2URH1679228840.jpg
@paavo2525
6 ай бұрын
@@DanielKornfeld www dot maskinisten dot net /userpix/22199_1EZ61P2YO2URH1679228840.jpg
@stefanlebherz3668
3 ай бұрын
Servus, wie habt ihr das Mit der Pumpeneinheit gelöst ? (umkehrgetriebe ) Ps. schönes Video
@DanielKornfeld
3 ай бұрын
@stefanlebherz3668 Servus! Ja richtig. Vor der Pumpe sitzt das Umkehrgetriebe. Danke 😁👍🌲
@laerchenstubemusic
6 ай бұрын
Na dann gleich mall zur wichtigsten Frage: was kost' des Ding (tutto completto) ?
@DanielKornfeld
6 ай бұрын
@laerchenstubemusic 90k tutto completto Mit großem Kran, Ölkühler und die Durchmesser Messung war damals auch Aufpreis.
@sthocka
6 ай бұрын
Blöde frage aber um 100k bekommt man schon einen top bagger mit kopf, war das nie eine Überlegung wert?
@DanielKornfeld
6 ай бұрын
@@sthocka Ja den bekommt man schon. Ein gebrauchter Harvester war in betracht. Der Hypro war kompakter und watrungsfreulicher.
@BadderflyHd-zs7uz
6 ай бұрын
Omg really hot stuff😅👌🏻
@DanielKornfeld
6 ай бұрын
@BadderflyHd-zs7uz Thanks!
@christianchristian5262
6 ай бұрын
Die Vorschubwalzen sind für meinen Geschmack zu agressiv eingestellt. Ohne Zopfsäge ist es wieder nur eine halbe Sache.
@DanielKornfeld
6 ай бұрын
@christianchristian5262 Wie meinst du das? Vom Anpressdruck oder von der Drehzahl? Das letzte Stück geht bei uns immer zum Hackgut. Eine Zopfsäge hätten wir noch nicht gebraucht.
Пікірлер: 23