Thanks for sharing your experiences. I plan to design some z scale Model Railroading elevated track supports. Your thoughts have been very helpful !
@darkfrei2
4 ай бұрын
What safe length can be 3d printed as bridge?
@luckeypolishing
3 жыл бұрын
Can you do this with PC/nylon and carbon fiber reinforced with those?
@webertim1007
2 жыл бұрын
How do you get the slicer to print straight lines (walls) from pillar to pillar? my slicer wants to do an infill pattern. I cannot manage to force it to only do lines.
@beastmode8365
2 жыл бұрын
he at 100% infill so he is force to do a line patteren
@alexandervouzenthal8163
3 жыл бұрын
How far can a standard 3d printer bridge ? I started planning and my printer hasn't arrived yet, and I plan my components in such way that bridging won't be needed, but it's not comfortable. I'm talking about 10-50 mm bridges
@TheEpiphanyShow
3 жыл бұрын
It depends on the printer and tuning really. I’d say 20 to 30mm is do able on almost any printer
@alexandervouzenthal8163
3 жыл бұрын
@@TheEpiphanyShow Thank you!
@littlesayonara3216
4 жыл бұрын
What cooling system do you have on your printer and what hotend?
@TheEpiphanyShow
4 жыл бұрын
Pets fang with 5015 and stock hotend
@noob64ilive
4 жыл бұрын
Hello. Why dose the cubes have the corners not sharp, i see they are a bit outside of model zone. I also get this issue with my ender3 and glass bead.
@TheEpiphanyShow
4 жыл бұрын
I was printing them too fast at 100mm/s
@EnergeticWaves
3 жыл бұрын
where did you find bridge setting in cura I can't
@YeetDisDude
3 жыл бұрын
You need to enable it by clicking the setting icon under the experimental tab
Пікірлер: 15